Where a 3 ft 10AN hose makes sense
Short runs are where this hose earns its place. The DeatschWerks 3 ft, 10AN stainless steel double braided CPE hose is intended for routing fuel lines in a compatible 10AN setup, so it suits compact connections between a pump, filter, rail, or regulator when the distance is measured in feet rather than yards.
The 3 ft length is not a universal fit. Measure your intended path before you order, and treat the hose as one segment in a larger 10AN plumbing plan rather than a one-size solution.
What the catalog confirms about this hose
-
3 ft, 10AN SS Double Braided CPE Hose: 10AN size, intended for 10AN hose end fittings The hose end size is the first compatibility checkpoint: your fittings must be 10AN to match.
3 ft, 10AN SS Double Braided CPE Hose
-
3 ft, 10AN SS Double Braided CPE Hose: Stainless steel double braided construction with CPE hose material These are the construction details the catalog lists; use them to confirm the hose matches the type of line you are building.
-
3 ft, 10AN SS Double Braided CPE Hose: 3 foot length The short length is best for a measured, compact run; longer routing needs a different length or multiple segments.
How to plan a short 10AN fuel run
The catalog does not supply routing instructions, torque values, or assembly procedures, so the steps below are planning checkpoints rather than manufacturer directions. Confirm assembly details with the fitting manufacturer and your own reference material.
- Map the path before you cut or order: Trace the route from the outlet to the inlet, including bends and any component you need to clear. A 3 ft hose only works if the measured path fits within that length with the bends your routing requires.
- Confirm 10AN at both ends: The hose is sized for 10AN hose end fittings. Check that every fitting in the run is 10AN; a mixed-size run will not connect.
- Decide whether one 3 ft segment is enough: For short connections between nearby components, a single 3 ft length may cover the run. For longer spans, plan additional length or a different hose length rather than stretching a short segment.
- Check the hose material against your setup: The catalog lists CPE hose material with stainless steel double braiding. Use that as your reference when comparing against the line you are replacing or the requirements of your fuel system.
Fitment details the catalog does not settle
The supplied record is clear on size, construction, material, and length, but it does not include operating instructions, temperature or pressure ratings, or a list of approved fluids. Treat those as open questions to resolve with DeatschWerks or your builder before assembly.
- Hose end compatibility beyond size: The catalog confirms 10AN sizing for 10AN hose end fittings, but it does not name specific fitting brands or styles. Match the hose to the fittings you plan to use.
- Routing and bend limits: No minimum bend radius or routing guidance is supplied. Plan a path with gentle bends and support points, and avoid sharp kinks that could stress the hose.
- Fluid and pressure ratings: The record does not list pressure or temperature limits. If your system operates at elevated pressure or temperature, verify suitability with the manufacturer before use.
A practical reason to choose the 3 ft length
If your layout needs a short, clean connection and you already run 10AN fittings, this hose keeps the run compact and avoids excess loops. The stainless double braid and CPE construction are the catalog-listed features to weigh against your build. At a catalog price of USD 24.70, it is a low-cost way to complete a short 10AN segment, but the right length still depends on your measurement, not the price.
For longer runs or different sizes, the same DeatschWerks hose family includes other lengths and sizes; this 3 ft 10AN version is the one to pick when your measured path fits within three feet.
