Which Decal Set Fits Your Rocket?

Before you apply any decals, confirm compatibility with your specific rocket model. The Decal Set - PML Black Brant VB is designed specifically for the PML Black Brant VB, so it's a perfect match if you're building that kit. For other rockets, Loc Precision offers vinyl decals for models like the Caliber ISP and Stovi. These sets are printed on premium cast vinyl with a gloss finish, using ECOSOL inks for vibrant, long-lasting graphics.

Check your rocket kit or airframe to ensure you order the correct decal set. Using a set meant for a different model may result in poor fit or design mismatch.

Preparing the Surface for Application

A clean, smooth surface is critical for a bubble-free, long-lasting decal application. Follow these steps before peeling the backing.

  1. Clean the area: Wipe the rocket body tube with a lint-free cloth and isopropyl alcohol to remove dust, oil, and fingerprints. Let it dry completely.
  2. Position the decal (dry fit): Place the decal on the rocket without removing the backing to check alignment. Mark light pencil lines at the edges to guide placement.
  3. Prepare a mild soap solution: Mix a few drops of dish soap with water in a spray bottle. This will let you reposition the decal slightly during application.

Applying the Vinyl Decal

These steps work for any vinyl decal set, including the Black Brant VB, Caliber ISP, and Stovi sets.

  1. Spray the rocket surface: Lightly mist the area where the decal will go with the soap solution. This temporary lubrication prevents the decal from sticking instantly.
  2. Peel and position: Carefully peel the decal from its backing. Place it on the wet surface, aligning with your pencil marks. Slide it gently into exact position.
  3. Squeegee out water and air: Using a soft squeegee or credit card wrapped in a soft cloth, push from the center outward to remove bubbles and excess soap solution. Work slowly to avoid wrinkles.
  4. Let it set: Allow the decal to dry undisturbed. The vinyl's advanced adhesive technology creates a permanent bond over time. Do not handle the rocket until the decal is fully set.

Decal Set Details That Matter

  • Decal Set - PML Black Brant VB: Designed specifically for the PML Black Brant VB. Vinyl construction for durable, long-lasting application. Easy to apply for a professional look. This set is a guaranteed fit for the PML Black Brant VB, so you won't struggle with size or design mismatch.

    Decal Set - PML Black Brant VB

    Decal Set - PML Black Brant VB

  • Decal Set Caliber ISP: Loc Precision's vinyl decals are printed on premium cast vinyl with a gloss finish using ECOSOL inks for high-impact, saturated graphics. The vinyl has advanced adhesive technology for permanent installation. The cast vinyl conforms well to curved surfaces, and the permanent adhesive means your decal stays put after application.

    Decal Set Caliber ISP

    Decal Set Caliber ISP

  • Decal Set Stovi: Same premium cast vinyl, ECOSOL inks, and gloss finish as the Caliber ISP set. Designed for the Stovi rocket model. You get the same high-quality materials and professional finish for the Stovi rocket.

Tips for a Professional Finish

Work in a clean, dust-free area at room temperature. Cold vinyl becomes stiff and harder to position; warm it slightly with a hair dryer on low if needed. Avoid touching the adhesive side with your fingers—oils can reduce adhesion.

If a small bubble remains, prick it with a pin and squeegee the air out. For larger wrinkles, lift the decal gently and reapply with fresh soap solution. Patience during the squeegee step makes the biggest difference in the final look.