About the Arcadian Heads x10 (Male) Set

The Arcadian Heads x10 (Male) set includes ten resin heads plus one spare helmet, all hand cast in high quality resin. These are 28mm heroic scale parts designed for experienced hobbyists. The multi-part nature means fitting and painting require some skill, but the results can add great variety to your miniature collection.

Key Product Facts

  • Arcadian Heads x10 (Male): Includes 10 heads and one spare helmet. You get a full set plus a bonus helmet for customization or replacement.

    Arcadian Heads x10 (Male)

    Arcadian Heads x10 (Male)

  • Arcadian Heads x10 (Male): Hand cast in high quality resin. Resin provides good detail retention and a smooth surface for painting.

  • Arcadian Heads x10 (Male): 28mm heroic scale troops. These heads are sized to fit 28mm heroic scale miniature bodies, ensuring proper proportion.

  • Arcadian Heads x10 (Male): Recommended for experienced hobbyists. Multi-part assembly and painting require some skill, so this set is best for those comfortable with resin miniatures.

Preparation and Fitting Steps

Before painting, you'll need to clean and fit the heads to compatible bodies. Here's a practical sequence.

  1. Clean the parts: Wash the resin heads in warm soapy water to remove any mold release residue. Rinse and let dry completely.
  2. Test fit: Dry-fit each head onto the intended body. The heads are 28mm heroic scale, so they should match similar-scale torsos. If the neck socket is too tight, gently sand the head peg or the body socket.
  3. Glue the head: Use a cyanoacrylate (super glue) or epoxy designed for resin. Apply a small amount to the peg and press the head into place. Hold for a few seconds until set.
  4. Fill gaps if needed: If there's a visible seam or gap, apply a thin layer of putty or green stuff epoxy. Smooth with a wet finger or tool before it cures.

Painting Tips for Resin Heads

Once assembled, prime the heads with a primer suitable for resin (acrylic or enamel). Use thin coats to preserve detail. For skin tones, start with a base coat of flesh tone, then layer shadows and highlights. The spare helmet can be painted separately and swapped for variety. Seal with a matte or gloss varnish depending on your desired finish.