Quick answer

Set up your Baby Brezza Steriliser Dryer Advanced Black and Bottle & Breast Milk Warmer bundle by placing both units on a dry counter, filling the steriliser's water tank, and choosing the correct warming mode for milk or formula.

Why the warming mode matters

The Bottle & Breast Milk Warmer in this bundle has two distinct modes. Steady Warm uses a warm water bath to gently heat breast milk without damaging its nutrients, while Quick Warm uses steam heat to rapidly warm formula or baby food. Choosing the wrong mode can either destroy breast milk proteins or take too long for a hungry baby.

Steriliser Dryer Advanced placement

Place the steriliser on a level, heat-resistant surface with at least 10 cm clearance above and behind for steam venting. Do not block the air intake at the rear. The unit uses a HEPA filter to dry bottles with filtered air, so ensure the filter is installed correctly before first use.

Step-by-step setup guide

  1. Unpack and inspect: Remove both units from the box. Check that the Steriliser Dryer Advanced includes the water tank, basket, lid, and HEPA filter. The Warmer should come with the base, warming bowl, and lid. Do not plug in until all packaging is removed. Common mistake: leaving foam or plastic inside the water tank can block water flow.
  2. Position and fill the steriliser: Place the steriliser on a dry, stable surface. Open the water tank lid and fill with tap water to the MAX line. Do not exceed this line, or water may spill during the drying cycle. Checkpoint: use filtered water if your tap water is hard to reduce limescale buildup.
  3. Install the HEPA filter: Open the filter compartment on the back of the steriliser. Insert the HEPA filter with the arrow pointing upward. Close the compartment door until it clicks. The filter is required for the drying function to work properly. Common mistake: forgetting to remove the plastic wrap from a new filter before installation.
  4. Set up the bottle warmer: Place the warmer on a flat surface near a power outlet. Add water to the warming bowl up to the indicated level. For breast milk, select Steady Warm mode. For formula or baby food, select Quick Warm mode. Checkpoint: always use fresh water each time; do not reuse water from previous cycles.
  5. Run a test cycle: Plug in both units. On the steriliser, press the Sterilise & Dry button to run a full cycle (about 45 minutes). On the warmer, press the power button and select a mode to confirm it heats. This ensures both units work before you need them. Common mistake: skipping the test cycle and discovering a fault only when you urgently need a sterile bottle.

Product facts

  • Baby Brezza BUNDLE Steriliser Dryer Advanced Black And Bottle & Breast Milk Warmer: The Bottle & Breast Milk Warmer is the only warmer with two warming modes: Steady Warm (warm water bath) and Quick Warm (steam heat). This lets you preserve breast milk nutrients when warming milk and still have a fast option for formula or baby food.

    Baby Brezza BUNDLE Steriliser Dryer Advanced Black And Bottle & Breast Milk Warmer

    Baby Brezza BUNDLE Steriliser Dryer Advanced Black And Bottle & Breast Milk Warmer