Start with the size range, not a guess

BAIO boots come in sizes 37 through 41, with half sizes from 37.5 to 40.5 and whole sizes at 39 and 41. That is a compact run, so the first step is honest: check where your usual boot size falls. If you normally wear a 36 or a 42, the supplied range does not cover you, and no amount of break-in will change that.

If you are between sizes, the mid-calf shaft makes the decision more than a foot-length question. A boot that feels right at the toes can still feel wrong around the calf, and the reverse is also true. Treat the size range as the boundary and the fit checks below as the way to choose within it.

What the BAIO record confirms

  • BAIO: Available sizes: 37, 37.5, 38, 38.5, 39, 40, 40.5 and 41. This is the full size run in the supplied record. If your usual size sits outside it, the BAIO is not a fit you can adjust into.

    BAIO

    BAIO

  • BAIO: Shaft height: 27 cm; heel: 3 cm. The 27 cm shaft is what makes this a mid-calf boot rather than an ankle boot, so calf fit matters alongside foot length. The 3 cm heel is the starting point for how the boot sits underfoot.

  • BAIO: Upper in earth suede, with leather lining and insole. Suede and leather lining are the two surfaces that touch your foot and leg. They shape how the boot feels on arrival and how it settles with wear.

  • BAIO: Genuine leather Blake-construction sole with a slightly inclined heel and rubber insert. Construction affects how the sole flexes and how the boot sits on the ground, which is part of judging fit when you first try them on.

How a leather boot should feel when you first put it on

A new leather boot should feel secure without pinching. Your toes need room to move, the widest part of your foot should sit at the widest part of the boot, and your heel should stay in place as you walk. The BAIO's leather lining and insole mean you are feeling leather against your foot, not a padded sockliner, so judge the fit on contact rather than on cushioning.

Use the side loops to pull the boot on without forcing the shaft. If you have to wrestle the boot past your heel or the shaft digs into your calf when you stand, that is a fit signal, not a break-in task. The supplied record does not include a break-in procedure, so do not assume the suede will stretch to solve a tight fit.

A practical BAIO fit check before you wear them outside

Try the boots on indoors, on a clean surface, at the end of the day when your feet are at their fullest. Walk for a few minutes and go through these checks in order.

  1. 1. Check the size against the run: Confirm you are trying one of the eight supplied sizes: 37, 37.5, 38, 38.5, 39, 40, 40.5 or 41. If your usual size is outside this range, stop here.
  2. 2. Check toe room: Stand up and press gently at the front of the boot. Your longest toe should not press against the front, and you should be able to wiggle your toes without the upper pinching.
  3. 3. Check the heel: Walk a few steps. A small amount of movement is normal in a new leather boot, but your heel should not lift clear of the insole with each step.
  4. 4. Check the shaft and calf: The BAIO shaft is 27 cm. Sit, stand and take a few steps. The shaft should sit without digging in or sliding down, and the side loops should not pull tight against your leg.
  5. 5. Check the flex point: The Blake-constructed leather sole will flex as you walk. Make sure the boot bends where your foot bends, not across the toes or too far back.

What to do if the fit is close but not right

If the BAIO feels slightly long or slightly short, first confirm you are comparing the right size against the run. Half sizes are available from 37.5 to 40.5, so there may be a nearer option than the whole size you started with. At size 39 and 41, the supplied record lists only the whole size, so there is no half-step to try.

If the foot feels right but the shaft feels tight or loose, changing size may not solve it. The supplied record gives the shaft height but not a calf circumference, so there is no number to check against your own measurement. In that case, judge the boot on how the shaft sits when you stand and walk, and treat any digging or slipping as a reason to reconsider rather than something to fix later.

Where the supplied information stops

The BAIO record confirms the size run, the 27 cm shaft, the 3 cm heel, the suede upper, leather lining and insole, and the Blake-constructed sole. It does not include a calf circumference, a width grading, a break-in procedure or care instructions. Those gaps are decision limits, not hidden features: if calf fit or a specific care routine is essential to you, ask before you buy rather than assuming.

That is also why this guide stops at the checks above. A leather boot fit guide can tell you what to feel for, but it cannot promise a universal fit. The BAIO is made in Italy in a defined size run, and the right pair is the one that passes the checks on your own feet.