What This Module Is Designed For

The DeatschWerks X2 module with two DW420 pumps and a PTFE plumbing kit is built for 1992–2006 BMW 3‑Series E36 and E46 models. This is a direct‑fit, dual‑pump assembly that replaces the factory module and supports higher fuel flow for modified engines. The included PTFE plumbing kit provides the necessary lines and fittings to connect the module to your existing fuel system.

If your E36 or E46 has a built motor, forced induction, or you simply want a reliable dual‑pump setup, this module removes the guesswork of piecing together separate components.

What the Catalog Confirms

Installation Steps

The following steps assume the fuel tank is accessible and the car is safely lifted. Always disconnect the battery negative terminal before starting fuel system work. Work in a well‑ventilated area and keep a fire extinguisher nearby.

  1. 1. Remove the factory fuel pump module: Relieve fuel pressure via the fuel rail test port or by pulling the fuel pump fuse and cranking the engine. Remove the access panel in the trunk or rear seat area, disconnect the electrical connector and fuel lines, and unscrew the locking ring. Lift the factory module out carefully to avoid damaging the tank.
  2. 2. Prepare the DeatschWerks X2 module: Inspect the new module and PTFE plumbing kit for any shipping damage. Attach the included PTFE lines to the module outlets using the supplied fittings. Ensure the O‑ring on the module flange is seated properly and lightly lubricated with clean fuel or silicone grease.
  3. 3. Install the new module: Lower the X2 module into the tank, aligning the orientation marks if present. Press the module down until the flange contacts the tank opening. Install the locking ring and tighten it to the torque specified by DeatschWerks (typically hand‑tight plus a quarter turn with a spanner).
  4. 4. Connect fuel lines and electrical: Route and connect the PTFE plumbing kit lines from the module to the engine bay fuel rail. Use the supplied fittings to secure each connection. Connect the module’s electrical harness to the car’s fuel pump connector. If your car uses a different connector, you may need to splice or adapt.
  5. 5. Test for leaks and operation: Reconnect the battery and turn the ignition to ON (do not crank) to prime the pumps. Check all connections for leaks. If none are found, start the engine and inspect again. Monitor fuel pressure with a gauge to confirm the dual pumps are working correctly.

Honest Trade‑Offs to Consider

The X2 module is a complete assembly, but it still requires careful routing of the PTFE lines through the chassis. PTFE hose is stiffer than rubber hose, so plan your path before cutting any lines. The supplied plumbing kit may not include every adapter needed for your specific engine bay configuration — check your existing fuel line fittings against the kit contents before starting.

Dual pumps draw more current than a single pump. Verify your fuel pump relay and wiring can handle the load, or consider upgrading the wiring harness if your car is older or has high mileage. The module is designed for E36/E46 chassis, but variations in tank design across model years may require minor adjustments — always test fit the module before reassembling the interior.

What the Catalog Does Not Settle

The supplied information does not include specific torque values for the locking ring, exact wire gauge for the pump harness, or a detailed PTFE hose routing diagram. These details depend on your particular vehicle and installation. If you are unsure about any step, consult a professional installer or refer to DeatschWerks’ official documentation.

The catalog also does not state whether the included PTFE kit is pre‑cut to length or requires trimming. Inspect the kit before starting and have a PTFE‑compatible cutter and reaming tool on hand if trimming is needed.