What the IsoNodes Large Set Does

The Bright Star IsoNodes Large set of four is designed to isolate heavier hi-fi components from shelf vibration. Each half-dome is made from Bright Star's own polymer, not Sorbothane, and has an adhesive backing that sticks to the chassis. The Large size is 1 1/4 inches across and 5/8 inch tall, rated to carry 42 pounds for a set of four.

This makes the Large set a natural fit for integrated amplifiers, power amplifiers, and other components that weigh more than a typical source but less than 42 pounds. If your component is close to that limit, Bright Star recommends taking the next size up or adding a fifth foot to spread the load.

Bright Star IsoNodes Large at a Glance

  • Bright Star - IsoNodes - Large - Set of Four: Rated 42 pounds for a set of four. This rating tells you the total weight the set can handle. For a component heavier than 42 lb, you need a fifth foot or the Extra Large set.

    Bright Star - IsoNodes - Large - Set of Four

    Bright Star - IsoNodes - Large - Set of Four

  • Bright Star - IsoNodes - Large - Set of Four: Each foot is 1 1/4 inches across and 5/8 inch tall. The size fits under most gear without raising it too high. Height added is 3/8 to 3/4 inch, so a low shelf still clears.

  • Bright Star - IsoNodes - Large - Set of Four: Made from Bright Star's own polymer, not Sorbothane. The material is soft and slightly tacky, but it's a different compound. If you specifically want a non-Sorbothane foot, this is it.

  • Bright Star - IsoNodes - Large - Set of Four: Adhesive backing holds each foot to the chassis. The feet stay on the component, not on the shelf. This matters if you slide gear in and out of a rack.

Choosing the Right Size by Weight

Bright Star rates each set for a total weight, so you pick the size by the component's weight. Weigh the component and choose the size whose rating covers it: Small up to 30 pounds a set, Large up to 42, Extra Large up to 60. If the weight sits close to a limit, take the next size up or add a foot.

The Large set is a good match for an integrated amp or power amp in the 30 to 42 pound range. For a component over 42 pounds, Bright Star says to add a fifth or sixth foot, or a second set. Two sets of Extra Large IsoNodes, eight feet, carry 120 pounds with the load spread evenly.

How to Install the IsoNodes

Installation is straightforward and requires no tools.

  1. Turn the component over: Place it on a clean, soft surface so you can access the underside.
  2. Peel the backing from each foot: Each IsoNode has an adhesive backing. Remove the protective film.
  3. Press one onto the underside near each corner: Place them clear of the stock feet. The adhesive holds the dome to the chassis.
  4. Set the component back on the shelf: Make sure it rests on the domes and sits level. Check that it does not rock.

What the IsoNodes Large Are Best For

The Large IsoNodes work well for components that are too heavy for the Small set but still within the 42-pound rating. Common candidates include integrated amplifiers, power amplifiers, and some heavier DACs or streamers. The adhesive backing keeps the feet in place when you slide the component in and out of a rack, which is a practical advantage over loose pucks.

If your component weighs more than 42 pounds, you have two options: add a fifth foot to the Large set or move up to the Extra Large set rated for 60 pounds. Bright Star says to add feet to carry a heavier component or to spread an uneven load.