Quick answer

Assemble the VLocker's Fiore Non-Scale DRACAENA SEFFIANA & NEBULA NOVA by carefully cleaning resin parts, test-fitting before gluing, and painting the white base coat to match the refined space-suit color scheme.

Why this kit needs a different approach

Unlike snap-fit plastic model kits, the VLocker's Fiore DRACAENA SEFFIANA is a resin kit. Resin requires washing to remove mold release, careful sanding of seam lines, and strong adhesive—no snap-together assembly. The white base color scheme also shows dust and fingerprints easily, so clean handling is critical from the start.

Assembly steps for the DRACAENA SEFFIANA

  1. 1. Wash and dry all resin parts: Soak each part in warm water with mild dish soap for 10-15 minutes, then scrub gently with an old toothbrush. Rinse thoroughly and let dry for at least 24 hours. Resin often has mold release residue that prevents paint from sticking. Skipping this wash can cause paint to peel later.
  2. 2. Remove mold lines and flash: Use a fine file or sandpaper (400-600 grit) to carefully sand away mold lines and any excess flash. Pay extra attention to curved surfaces—over-sanding can flatten details. Resin dust is toxic, so wear a mask and work wet or in a ventilated area. Always sand wet or wear a respirator; never dry-sand resin indoors without protection.
  3. 3. Dry-fit all parts before gluing: Assemble the kit without glue to check fit. Resin kits often have warped or misaligned parts. Mark any areas that need sanding or filling with a pencil. Adjust fit by sanding the contact surfaces gradually. Forcing a tight joint can crack the resin; sand a little at a time.
  4. 4. Glue with cyanoacrylate (CA) or epoxy: Apply a small drop of CA glue (super glue) to one side of the joint, press together, and hold for 10-20 seconds. For larger or load-bearing joints, use a two-part epoxy. Avoid plastic cement—it won't bond resin. CA glue can fog clear parts; use a dedicated clear-part glue or epoxy for transparent sections.
  5. 5. Fill gaps and seams: Use putty or CA glue mixed with baking soda to fill any gaps between parts. Apply with a toothpick, let cure, then sand smooth. Resin kits often have visible seams that need filling for a seamless look. Let filler cure fully before sanding to avoid shrinking or cracking.
  6. 6. Prime and paint the white base coat: Apply a light gray or white primer to check for imperfections. Sand any rough spots with 800-grit paper. Then spray a thin, even coat of white paint (lacquer or acrylic). Build up in light layers to avoid obscuring fine details. A white primer helps the final white coat cover evenly and prevents the resin's natural color from showing through.
  7. 7. Final assembly and detailing: Attach any remaining small parts (antennae, weapons, etc.) with CA glue. Paint small details like panel lines or metallic accents by hand. Apply a clear matte coat to protect the finish and reduce glare. Test fit small parts before gluing—they are easy to lose or break.

Kit features to note

  • VLocker's Fiore Non-Scale DRACAENA SEFFIANA & NEBULA NOVA: The design has evolved from dark colors reminiscent of the pitch-black universe to a refined white base color scheme, almost reminiscent of a space suit. The white finish means you must work with clean hands or gloves to avoid oils and dust showing through the final paint.

    VLocker's Fiore Non-Scale DRACAENA SEFFIANA & NEBULA NOVA

    VLocker's Fiore Non-Scale DRACAENA SEFFIANA & NEBULA NOVA