Quick answer
Stretch the BumpHer Stimulator Cushion over the base of your strap-on dildo before putting on the harness, then adjust the double-bump side so it rests against your vulva. Use water-based lubricant and check the fit before thrusting.
Why the BumpHer changes harness play
In harness play, the penetrating partner often feels the hard base of the dildo pressing against their body with every thrust. The BumpHer adds a soft, squishy layer that turns that pressure into something more comfortable and, for many people, more stimulating. Its double-bump shape is designed to give you something to rub against, so the motion works for you too.
The trade-off is that adding a sleeve changes the fit of your harness. A dildo that sat flush before may now feel slightly bulkier at the base, and you may need to adjust strap tension. That extra step is worth it if comfort or external stimulation has been missing from your setup.
Positioning matters more than pressure
The cushion only helps if the bumps land where you want them. Because the BumpHer stretches over the base, you can rotate it before play to line the double-bump design up with your clitoris or vulva. Take a minute to check the alignment while standing or lying down, since the angle changes once you start moving.
Avoid the common mistake of jamming the dildo in place and hoping the cushion self-adjusts. If the bumps sit off to one side, you will feel pressure in the wrong spot and may tighten the harness to compensate, which defeats the purpose. A quick rotation before you fasten the harness solves most of this.
Lubricant and material compatibility
The BumpHer is made of soft silicone, so stick with water-based lubricant. Silicone-based lubes can degrade silicone toys over time, and you do not want the cushion to become tacky or torn. Apply a small amount to the bump side and to the base of the dildo before you slide the sleeve on; a little goes a long way.
If you are using a condom on the dildo, put the BumpHer on first, then the condom, so the sleeve does not roll the condom's base. Check that the condom still covers the shaft fully after the cushion is in place.
Step-by-step: using the BumpHer Stimulator Cushion
- Check the dildo base: Choose a dildo with a flared base that fits the BumpHer sleeve. Stretch the sleeve over the base before attaching the dildo to the harness. Common mistake: trying to stretch it on after the dildo is already locked into the harness, which is fiddly and can trap air. If the base is too small, the sleeve may slip; if too large, it may not seat fully. Test the fit with the dildo in your hand first.
- Rotate for alignment: With the sleeve on, rotate it so the double-bump side faces the spot you want stimulated. Put the harness on and check the alignment while standing, then lie down and recheck. Common mistake: assuming the bumps are centered when they are actually offset. Mark the bump side with a small dot of water-based lube or remember the seam position so you can reorient quickly.
- Adjust harness tension: Fasten the harness straps so the dildo sits snug but not tight. The added cushion can make the base feel bulkier, so you may need to loosen straps slightly compared with your usual fit. Common mistake: over-tightening to keep the dildo steady, which presses the bumps too hard against you. Do a few slow thrusts in the air or against a pillow to feel whether the cushion stays put without excessive pressure.
- Apply water-based lubricant: Add a few drops of water-based lube to the bump side and to the inside of the sleeve where it meets the dildo base. Common mistake: using silicone lube, which can damage silicone toys over time. Keep a small bottle of water-based lube nearby for quick touch-ups; reapply if the cushion starts to drag.
- Start slow and communicate: Begin with gentle thrusts and ask your partner for feedback on angle and pressure. The BumpHer is designed to add stimulation, but the right rhythm varies by person. Common mistake: going straight to fast, deep thrusts before checking that the cushion is comfortable and secure. If you feel pinching or slipping, stop and readjust the sleeve or harness before continuing.
- Clean after use: Remove the BumpHer from the dildo and wash it with warm water and mild soap, then rinse thoroughly and let it air dry. Common mistake: leaving it on the dildo to dry, which can trap moisture and odor. Store the cushion separately from other silicone toys to avoid contact that can cause surface damage.
Product facts
-
BumpHer Stimulator Cushion: Soft, supple, and super squishy silicone sleeve that stretches over the base of a strap-on dildo. The stretchy fit means you can use it with a range of dildo bases, but you still need to check that it sits securely before thrusting.
BumpHer Stimulator Cushion
-
BumpHer Stimulator Cushion: Unique double-bump design covers the base to give the penetrating partner something to rub against. Rotate the sleeve so the bumps align with your anatomy; otherwise the stimulation lands in the wrong place.
