What Fits a 7.51" Airframe?

Centering rings for 7.51" airframes are designed to fit inside airframe tubes with an inner diameter of 7.51" and an outer diameter of 7.675". These rings also slide over motor mount tubes of various sizes, making them a key component for aligning and securing the motor mount inside the airframe.

The catalog lists multiple variants for different motor mount diameters and cluster configurations, so choosing the right one depends on your motor setup and recovery attachment preferences.

Centering Ring Variants at a Glance

  • Centering Rings for 7.51" Airframe: CR-7.51-38mm: Centering rings for BT-7.51 to 38mm mount. 2 pack 1/4″ thick, includes SCM3 1/4″ eye bolt and Z clip motor retention. This is the simplest single-mount option for a 38mm motor, with built-in recovery attachment hardware.

    Centering Rings for 7.51" Airframe

    Centering Rings for 7.51" Airframe

  • Centering Rings for 7.51" Airframe: CR-7.51-54mm: Centering rings for BT-7.51 to 54mm mount. For builders stepping up to a 54mm motor, this variant provides the same 1/4″ thickness in a 2-pack.

  • Centering Rings for 7.51" Airframe: CR-7.51-98mm: Centering rings for BT-7.51 to 98mm mount. 2 pack 1/4″ thick, includes SCM-4 U Bolts for recovery attachment. The largest single-mount option uses U-bolts instead of an eye bolt for heavier recovery loads.

Single-Mount vs. Cluster Options

The catalog offers centering rings for single motor mounts (38mm, 54mm, 75mm, 98mm) and several cluster configurations. Each cluster variant specifies the number and size of motor tubes it accepts.

  • Single-mount rings: Available for 38mm, 54mm, 75mm, and 98mm motor mounts. All come in 2-packs with 1/4″ thickness. The 38mm and 98mm versions include recovery attachment hardware.
  • Cluster rings: Configurations include 1x54mm + 4x38mm, 1x75mm + 4x38mm, 1x98mm + 4x29mm, 1x75mm + 4x38mm + 4x29mm, 1x98mm + 8x29mm, 1x54mm + 4x29mm, 7x54mm, and 5x54mm. These allow multi-motor setups for higher thrust or redundancy.

Checking Fit Before Gluing

Before applying any adhesive, dry-fit the centering ring into the airframe tube and over the motor mount tube. The ring should slide in with a snug fit — not too loose, not requiring excessive force. If you're using a cluster ring, verify that each motor tube opening aligns correctly with your planned motor arrangement.

The supplied information does not specify exact glue type or gap tolerances, so follow your motor manufacturer's recommendations and your own build experience. For rings that include hardware (eye bolts, Z clips, or U-bolts), ensure the hardware is oriented for easy access after installation.

Recovery Attachment Considerations

Some centering ring variants include hardware for attaching recovery harnesses. The CR-7.51-38mm comes with an SCM3 1/4″ eye bolt and Z clip motor retention. The CR-7.51-98mm uses SCM-4 U Bolts. If you choose a variant without included hardware, you'll need to supply your own attachment point, such as a separate bulkhead or anchor.

For cluster rings, the catalog does not specify included hardware, so plan accordingly for how you'll attach your parachute or recovery system.