Quick answer

Install Billetworkz Climate Control Covers on your Subaru Crosstrek (2018+) in minutes—no tools, no adhesive, just a secure press-fit upgrade.

Why upgrade your climate control knobs?

Factory climate control knobs work fine, but they lack personality. Billetworkz covers add a custom touch without permanent modification. They slide directly over the stock knobs, preserving full function while upgrading the look.

The press-fit design means you can swap colors or revert to stock anytime. If the fit feels slightly loose, a small strip of tape on the inner surface tightens it up—no glue or tools required.

Installation steps

  1. Step 1: Remove the factory knobs: Pull each factory climate control knob straight off. They are friction-fit—no tools needed. If they resist, gently rock them side to side while pulling. Do not twist or pry; you may damage the plastic stem.
  2. Step 2: Prepare the Billetworkz cover: Inspect the inner surface of the cover. If it feels loose on the knob stem, apply a small strip of double-sided or masking tape inside the cover. This ensures a snug press-fit. Test fit before adding tape; too much tape can make it hard to seat.
  3. Step 3: Press the cover onto the stem: Align the cover with the knob stem and push firmly until it clicks or sits flush. Rotate the cover to your preferred orientation—the knob function remains unchanged. If the cover is crooked, remove and re-seat it immediately before the tape sets.

Product facts