Quick answer
On a 1982-and-up Club Car DS, install the Instamatic LED kit by test-fitting the bezels and templates before drilling, routing the supplied harness along the existing frame path, and aiming the adjustable headlights after the battery is reconnected.
Why the adjustable bezels change the drilling plan
The Club Car DS Adjustable LED Light Kit (1982 and UP)- Instamatic® uses thick injection-molded plastic bezels with adjustable all-LED headlights. Because the headlight position can be tuned after mounting, you have some margin for error in the cutout—but the bezel still has to sit flush against the cowl.
That is why the kit includes light templates. Use them to mark the cutout, then hold the actual bezel against the mark before you cut. If the template and bezel disagree on your cart's cowl shape, trust the bezel.
Where the DS kit differs from newer Club Car models
This kit is listed for Club Car DS models from 1982 and up, not for Tempo or Onward carts. If you are working on a different model, the mounting points and cowl contours will not match this kit's templates.
The DS also has variations across its long production run. The catalog does not list separate sub-model fitments, so confirm your cart is a DS before you drill. If you are unsure, check the serial plate or compare your cowl to the supplied templates first.
Instamatic LED light kit install steps for Club Car DS
- Disconnect the battery pack: Switch the cart to tow/maintenance mode if equipped, then disconnect the main negative and positive cables before touching any wiring. Confirm the cart is fully powered down before drilling or cutting near the cowl.
- Test-fit the templates and bezels: Tape the supplied light templates to the front cowl, check alignment side to side, and hold each bezel against its template. Mark the cutout only after the bezel sits flush. If the template and bezel do not line up, adjust the template—not the bezel.
- Cut and drill the headlight openings: Drill pilot holes at the template corners, then cut the opening with the method your cowl material allows. Deburr the edges so the bezel seats flat. Start with a smaller opening and file to fit; an oversized cut will leave a visible gap around the bezel.
- Mount the headlights and tail lights: Feed the headlight pigtails through the cowl, seat each adjustable bezel, and secure it with the supplied attachment screws. Mount the two LED tail lights at the rear using the same hardware set. Leave the bezel screws slightly snug until you have checked beam aim later.
- Route the wiring harness: Run the harness from the front cowl along the frame or existing loom path to the rear lights and battery area. Secure it with the supplied zip ties, keeping it clear of moving suspension and steering parts. Leave a small service loop at each light so the harness is not under tension.
- Make the connections: Connect the headlight and tail light pigtails to the harness connection points, then connect the harness to the battery source per the included directions. Check every connector is fully seated before restoring power; a loose connection is the most common cause of one light not working.
- Reconnect and test: Reconnect the battery cables, switch the cart out of tow mode, and test low and high beam plus tail lights. If a light does not work, recheck the harness connection at that light before suspecting the LED itself.
Kit facts that affect the install
-
Club Car DS Adjustable LED Light Kit (1982 and UP)- Instamatic®: The kit includes two adjustable all-LED headlights, two LED tail lights, a wiring harness with connection points, directions, zip ties, attachment screws, and light templates. You should not need extra mounting hardware for a standard DS install, but you will need your own drill, bits, and wire-routing tools.
Club Car DS Adjustable LED Light Kit (1982 and UP)- Instamatic®
Club Car DS Adjustable LED Light Kit (1982 and UP)- Instamatic®