Quick answer
To install the CRKD Gibson Les Paul Faceplate Skin in Blueberry Burst Matte, clean the controller surface, peel and align the skin carefully, then press from center outward to avoid bubbles.
Why a careful install matters
The matte finish of this Blueberry Burst skin is designed to preserve the original look of your Gibson Les Paul controller while adding protection. A rushed installation can leave dust trapped under the skin or cause misalignment that ruins the clean aesthetic.
The reusable adhesive backing means you can reposition the skin during the first few seconds, but once fully pressed, it bonds tightly. Taking your time during the alignment phase prevents the need to peel and reapply later.
Installation steps
- Clean the controller surface: Wipe the faceplate with a microfiber cloth and isopropyl alcohol to remove oils, dust, and residue. Let it dry completely. Skipping this step can trap particles under the skin, causing visible bumps.
- Peel and align the skin: Peel a small corner of the backing paper. Hold the skin over the controller and align the cutouts for buttons and ports. Once positioned, press the exposed corner to hold it in place. Start alignment at the center of the faceplate; it is easier to adjust edges than the middle.
- Press from center outward: Slowly peel the rest of the backing while pressing the skin down from the center toward the edges with a soft cloth or squeegee. This pushes air bubbles outward. If a bubble forms, lift the nearest edge slightly and re-press. Do not try to pop it with a pin—it will leave a visible mark on the matte finish.
Product facts
-
CRKD Gibson Les Paul Faceplate Skin Blueberry Burst (Matte): Crafted with premium polycarbonate and easy-apply reusable adhesive backing. The reusable adhesive gives you a short window to adjust alignment before permanent bonding, reducing the chance of a crooked install.
CRKD Gibson Les Paul Faceplate Skin Blueberry Burst (Matte)
