Start With the Fixed Collar

The DFDTM X2 Boost uses a fixed collar system, so the neck opening is set by the jacket's design rather than a strap you tighten. That makes the collar your first checkpoint: the jacket should sit high enough that the foam supports the chest and the collar rests comfortably around the neck without pressing on the throat.

Because the collar is fixed, most of your fitting work happens at the dual adjustment points. Before you fasten anything, slip the jacket on and check that the collar sits where it should. If it rides too low or feels tight at the throat, the size is likely wrong rather than the adjustment.

Adjust the Dual Points for a Snug, Flexible Fit

The X2 Boost is built with dual adjustment points, which let you fine-tune the body of the vest independently of the collar. Work through these checkpoints with your dog standing on dry land.

  1. Fasten the jacket loosely first: Close the adjustment points without pulling them tight. This lets you see how the foam panels sit on your dog's chest and back before you tension anything.
  2. Tighten one side at a time: Take up slack gradually at each adjustment point. A snug fit keeps the ultra-buoyant foam in contact with your dog's body, which is what lets the vest do its job in the water.
  3. Check for two-finger room at the body: You want the jacket close enough that it does not slide, but loose enough that you can still slip a couple of fingers under the body straps. If you cannot, back off the adjustment.
  4. Recheck the collar after tightening: Tightening the body can shift how the fixed collar sits. Look again at the neck opening and make sure it has not crept up or twisted.
  5. Test movement before water: Ask your dog to walk, sit, and turn. The jacket should move with the body, not hang away from it or bunch at the shoulders.

Use the Grab Handle and Light Point as Fit Checks

The heavy-duty reinforced grab handle is a useful fitting gauge. With the jacket on and adjusted, lift gently at the handle. The vest should stay in place around the body rather than sliding up toward the neck. If it rides up, your adjustment points are probably too loose.

The light attachment point is another checkpoint. A light clipped there should sit clear of your dog's movement and not pull the jacket sideways. If the attachment point twists the vest, revisit the dual adjustment points before you head to the water.

What the X2 Boost Is Built For

  • DFD™ X2 Boost: Designed for superior buoyancy, comfort, and visibility with a fixed collar system, ultra-buoyant foam, and dual adjustment points. The fixed collar and dual adjustment points are the two features that shape how you fit this jacket, so knowing them helps you adjust in the right order.

    DFD™ X2 Boost

    DFD™ X2 Boost

  • DFD™ X2 Boost: Features a heavy-duty reinforced grab handle, reflective piping, and a light attachment point. These details give you practical checkpoints for fit and visibility once the jacket is on.

  • DFD™ X2 Boost: Available in sizes 4XS through XL in Yellow, and 4XS through XS in Red. Size availability differs by color, so check the size you need before choosing a color.

Flotation Tips for the First Swim

A well-fitted X2 Boost supports your dog, but it does not replace supervision. Start in shallow, calm water and stay within arm's reach. Let your dog paddle and find its balance before you move into deeper water.

Use the grab handle to guide your dog back to shore or into the boat rather than lifting by the collar. The handle is reinforced for exactly this kind of support.

The reflective piping and light attachment point help with visibility, but they work best when the jacket is correctly adjusted. A vest that shifts around reduces both comfort and the effectiveness of those visibility features.

Fit Problems and What to Adjust

  • Jacket rides up toward the neck: The body adjustment points are too loose. Tighten them gradually and recheck the collar.
  • Collar presses on the throat: The size may be too small or the jacket may be sitting too high. Because the collar is fixed, adjustment alone may not solve this — check the size chart.
  • Jacket twists to one side: One adjustment point is tighter than the other. Even out the tension on both sides.
  • Grab handle pulls the vest out of shape: The fit is too loose overall. Re-tighten both adjustment points and test the handle again.