Quick answer
Install the Dome Gen 2 Stand Wing Accessory Pegs by sliding each peg into the pre-drilled holes on the stand wings, then hang your tools and accessories securely. These pegs come standard with the stand, so you only need to buy spares if the originals are lost or damaged.
Why use the wing pegs?
The wing pegs turn the unused side panels of your Dome Gen 2 Stand into a convenient storage area. Instead of leaving your peel, brush, or gloves on the ground, you can hang them within arm's reach while you cook.
Because the pegs are included with the stand, the main reason to buy a replacement pack is if you've lost or broken one of the originals. Keep a spare set on hand so you don't have to wait for shipping if a peg goes missing mid-season.
Know your pegs before you start
Each pack contains six pegs, which is enough to fill all the wing slots on a standard Dome Gen 2 Stand. The pegs are designed to fit snugly into the stand's pre-drilled holes, so no tools are needed for installation.
Before you begin, check the product manual to confirm that these pegs match your specific stand model. If you have a different generation or an accessory stand, the fit may not be the same.
Step-by-step installation and use
- Gather the pegs and inspect the stand: Take the six pegs out of the pack and lay them next to your Dome Gen 2 Stand. Look at the wing panels to find the pre-drilled holes where the pegs will go. Make sure the holes are clear of debris or grease. Don't force a peg into a hole that looks blocked—clean it first with a dry cloth.
- Insert each peg into a wing hole: Hold a peg by its base and push it straight into a hole until it sits flush against the wing. Repeat for all six pegs, spreading them evenly across both wings. No tools or twisting are required. If a peg feels loose, remove it and try a different hole—the fit should be snug but not tight.
- Hang your accessories: Place the handle of your peel, brush, or other tools over a peg. Make sure the accessory is balanced and won't swing into the oven or onto the ground. Hang heavier items on lower pegs to keep the stand stable. Avoid overloading a single peg—spread heavy tools across multiple pegs to prevent bending.
- Check the pegs regularly: Before each cook, give the pegs a quick visual check. If a peg has worked loose, push it back in. If it's cracked or broken, replace it with a spare from your pack. Store spare pegs indoors to prevent weather damage and keep them ready for replacement.
Product facts
-
Dome Gen 2 Series Stand Wing Accessory Pegs: A pack of 6 accessory pegs featured on the Dome Gen 2 Stand to hang accessories from. This part is included with the original product as standard. Since the pegs come with the stand, you only need to purchase this pack as a replacement if the originals are lost or damaged—so check your stand before ordering.
Dome Gen 2 Series Stand Wing Accessory Pegs