Quick Answer
Installing the Dome Gen 2 Series Stand Wooden Wings is a straightforward process that requires no tools, but getting the alignment right is key to a stable and level work surface.
What Are the Wooden Wings For?
The wooden wings are optional side extensions for the Dome Gen 2 stand. They give you extra prep space next to the oven, which is handy when you are stretching dough, holding toppings, or resting a peel. Because they are made from acacia wood, they match the stand's look and resist outdoor weather reasonably well, but they are not meant to be left in heavy rain or direct sun for long periods.
When You Might Need a Replacement Set
The wooden wings come standard with the Dome Gen 2 stand. You would only need to buy a spare set if the original wings are lost, cracked, or warped. Before ordering, check your product manual to confirm compatibility—the wings are designed specifically for the Dome Gen 2 stand and will not fit older models or the Dome XL stand without modification.
How to Install the Dome Gen 2 Stand Wooden Wings
- 1. Clear the Stand Rails: Make sure the side rails of the Dome Gen 2 stand are free of debris, grease, or old wing fragments. The wings slide into the rail channels, so any obstruction will prevent a flush fit. Check that both rails are clean and dry before you start.
- 2. Align the Wing with the Rail Channel: Hold the wooden wing so the metal bracket faces downward and the wood surface is level. Slide the bracket into the rail channel at a slight angle, then push it straight until it stops. A common mistake is forcing the wing in at the wrong angle, which can scratch the bracket or the rail. If it does not slide easily, adjust the angle rather than pushing harder.
- 3. Lock the Wing in Place: Once the wing is fully seated, press down gently on the wood surface to engage the locking mechanism. You should hear or feel a click. Give the wing a light tug to confirm it is secure. If it wobbles, remove it and check that the bracket is not bent. A loose wing can tip when you place a heavy stone or tray on it.
- 4. Repeat for the Opposite Side: Install the second wing on the other side of the stand using the same steps. Both wings should sit at the same height and be parallel. If one side sits higher, the stand may be on uneven ground. After both wings are installed, place a level across them to verify the surface is flat.
Product Facts
-
Dome Gen 2 Series Stand Wooden Wings: This is a spare set of acacia wood wings for the Dome Gen 2 stand. The part is included with the original product as standard. If your original wings are damaged or missing, this replacement restores the full work surface without needing to buy a new stand.
Dome Gen 2 Series Stand Wooden Wings