What This Hood Prop Replaces

The stock steel hood prop on your Mitsubishi Lancer Evolution VII, VIII, or IX [CT9A] does the job, but it's heavy and plain. The Argon Bubble Titanium Hood Prop is a direct replacement that weighs approximately 40% less than the stock piece while adding a distinctive look under the hood. It fits all USDM and JDM models from 2001-2005.

Product Evidence

Installation Steps

Installing the Titanium Hood Prop is straightforward and requires only basic hand tools. No drilling or modification is needed.

  1. Step 1: Remove the stock hood prop: Open the hood and secure it with a secondary support. Unclip the stock prop from its ball studs on the hood and the fender. Set the stock prop aside.
  2. Step 2: Install the titanium prop: Align the titanium prop's ball socket with the same ball studs. Press firmly until the socket snaps into place. Repeat for both ends.
  3. Step 3: Test operation: Lower the hood and check that the prop holds it securely. The titanium prop should function identically to the stock unit.

Fitment Notes

This prop is designed specifically for the Mitsubishi Lancer Evolution VII, VIII, and IX [CT9A] chassis. It fits both USDM and JDM models without modification. The prop uses the existing ball studs, so no additional hardware is needed.

If your stock ball studs are worn or damaged, replace them before installing the titanium prop to ensure a secure fit.

Choosing Your Finish

The titanium hood prop is available in two finishes: Polished and Burnt. The polished finish offers a bright, mirror-like appearance, while the burnt titanium finish shows heat-induced colors ranging from blue to purple. Both options are equally durable; the choice is purely cosmetic.