Quick answer

Use the Philips Hue 5m outdoor extension cable to bridge the gap between your power supply and your first light point, or to space out multiple lights. Just keep the total system length per power supply within the 35-meter limit.

Why use the Hue 5m extension cable?

The 5m extension cable is designed specifically for Philips Hue outdoor lighting. It lets you place lights where you need them, even when the power supply isn't close. This is especially useful for gardens, patios, or driveways where the nearest outlet is far from the first light point.

One key trade-off: every meter of extension cable adds to the total system length, and the maximum per power supply is 35 meters. Plan your layout to avoid exceeding this limit, which can cause voltage drop and dimmer lights.

Important safety and compatibility checks

Before you start, make sure the extension cable is rated for outdoor use and is compatible with your Philips Hue outdoor lights. This cable is designed for that purpose, but always verify that your power supply and light fixtures are outdoor-rated.

Also, check that all connections are dry and clean before plugging in. Moisture is the most common cause of outdoor lighting failures. Use the provided caps or covers to protect unused connectors.

Step-by-step setup guide

  1. Plan your layout: Measure the distance from your power supply to the first light point, and between each light point. Add up all the cable lengths you'll need, including the extension cable(s), and make sure the total is under 35 meters. Always sketch your layout and note the total length before buying or installing.
  2. Connect the extension cable to the power supply: Plug the 5m extension cable into the outdoor power supply first. Make sure the connection is secure and the locking ring (if any) is tightened. This avoids accidental disconnection and water ingress. Double-check that the connector is fully seated and locked before moving on.
  3. Run the cable to your first light point: Lay the cable along your planned route, avoiding sharp bends or areas where it could be tripped over or cut by garden tools. Use cable clips or bury it (if the cable is rated for burial) to keep it tidy and safe. If you need to cross a walkway, use a cable protector or bury the cable to prevent damage.
  4. Connect the light fixture: Attach your Philips Hue outdoor light to the other end of the extension cable. Ensure the connection is dry and clean before plugging in. If the light has a connector cap, remove it only when ready to connect. Always keep the connector cap on until you're ready to connect to prevent moisture buildup.
  5. Power on and test: Plug the power supply into a mains outlet and switch it on. Check that the light turns on and responds to the Hue app. If the light is dim or flickering, you may have exceeded the cable length limit or have a loose connection. If you experience issues, unplug and recheck all connections before troubleshooting further.

Product facts

  • Extension cable for outdoor use 5m: The extension cable can be used to extend the space between the power supply and your first light point or to extend the space between lightpoints. Total maximum system length per power supply is 35 meters. This means you can position lights exactly where you want them, but you must stay within the 35-meter total to ensure consistent performance.

    Extension cable for outdoor use 5m

    Extension cable for outdoor use 5m