Quick answer
Use a Ferro Split-Bar G-Hook when you need to add or replace a 1-inch G-hook on existing webbing without taking the strap apart. If the hook is loose because the webbing has worn thin or the hook is bent, stop and replace the webbing or the whole strap instead of swapping hardware.
Why a split-bar hook changes the job
A standard G-hook has a closed bar, so installing it means opening a seam, removing stitching, or disassembling the strap. The Ferro Split-Bar G-Hook has a split bar that slides onto an existing loop of webbing. That makes it a practical fix for adding a hook to a front flap or replacing a damaged hook on a shoulder strap without rebuilding the strap.
The trade-off is that the split bar is not a repair for worn webbing. If the webbing itself is frayed, stretched, or too thin to hold the hook securely, a new hook will not fix the looseness.
When to stop and choose another option
Stop if the webbing is torn, heavily frayed, or has lost stiffness across the area where the hook sits. Also stop if the hook itself is bent or the spring gate no longer closes with tension. In those cases, replace the webbing section or the full strap rather than installing a new hook on a compromised base.
If you need a hook on webbing wider or narrower than 1 inch, the Ferro Split-Bar G-Hook is not the right part. It is made for 1-inch webbing, and forcing it onto other widths can damage the webbing or leave the hook insecure.
Diagnose your strap hardware problem
- Symptom: Hook slides or rotates freely on the webbing: Check whether the webbing is worn thin or the hook is the wrong width. If the webbing is intact and 1 inch wide, a split-bar G-hook can restore a secure fit by replacing a stretched or undersized hook.
- Symptom: Hook gate does not close or feels weak: Inspect the gate for bends or debris. If the gate is deformed, replace the hook. A split-bar G-hook installs without disassembly, so you can swap it directly onto the existing webbing loop.
- Symptom: You need to add a hook to a front flap or shoulder strap: Use the Ferro Split-Bar G-Hook on 1-inch webbing. Slide the split bar onto the existing loop, then test the gate and load before carrying. No stitching or seam opening is required. If the webbing is not 1 inch wide, stop and choose a hook sized for that webbing.
- When to stop and replace more than the hook: If the webbing is frayed, torn, or permanently stretched, or if the hook attachment point is damaged, do not install a new hook. Replace the webbing or the entire strap assembly instead.
Product facts
-
Ferro Split-Bar G-Hook: Custom Split-Bar design, 1-inch width, made in USA. The split bar lets you slide the hook onto existing 1-inch webbing without disassembling the strap.
Ferro Split-Bar G-Hook