Quick answer

Start with a short, low-speed session on a stable surface, apply plenty of water-based lube, and keep the remote or controls within reach before you turn the machine on. Treat the first run as a test of fit, noise and comfort rather than a full session.

Why the first session should be short and slow

A fully automatic sex machine does the movement for you, so the main risk on a first session is overestimating how much thrusting you want. The telescopic stroke on the Lurevibe unit is 52mm, which is enough travel to feel clearly different from a manual toy. Begin with the lowest setting and stop after a few minutes to check for friction, pinching or numbness.

The heating function adds warmth, but it also means you should test the temperature before a long session. Switch it on briefly, let the sleeve reach a comfortable level, and keep the first heated run short.

Noise and setup limits to plan around

The listed noise level is above 65dB, so this is not a whisper-quiet device. If privacy matters, run it on a folded towel or rug to reduce vibration transfer through the floor, and avoid late-night sessions in a shared wall apartment until you know how it sounds in your room.

The machine is life waterproof, not submersible. Keep it out of the bath or shower and clean the sleeve and attachments separately rather than rinsing the whole motor unit.

First-session steps

  1. Set up on a stable, washable surface: Place the machine on a flat surface such as a bedside table or floor mat, with a towel underneath to catch lube and reduce vibration. Check that the power cable or controls are within easy reach before you start. If the machine can slide or tip when you press against it, stop and reposition before turning it on.
  2. Attach the sleeve and apply water-based lube: Fit the included dildo or your chosen attachment securely, then apply a generous amount of water-based lube to both the sleeve and yourself. Reapply during the session rather than waiting for friction to build. Silicone-based lube can degrade silicone sleeves, so check the lube label before use.
  3. Test the heating function separately: Turn on the heating feature for a short time before combining it with movement. Let the sleeve warm up, then touch it to confirm the temperature feels comfortable before you use it. If the warmth feels sharp or uneven, switch heating off and use the machine without it.
  4. Start at the lowest speed and shortest stroke: Begin with the slowest telescopic setting and a short stroke if your model allows adjustment. Spend two or three minutes there to check alignment and comfort before increasing anything. Increase one setting at a time, and only after you have confirmed the current one feels right.
  5. Pause and check in every few minutes: Stop the machine briefly to check for pinching, numbness or slipping. Adjust your position, add lube, or lower the speed if anything feels off. A first session that ends early is normal; you are testing fit, not chasing duration.
  6. Clean and dry before storage: Remove the sleeve and wash it with warm water and toy cleaner, then let it air-dry completely. Wipe the motor unit with a damp cloth only, and store everything away from direct heat. Never store the sleeve while it is still damp, and keep the motor unit unplugged during cleaning.

Product facts that affect first use