Start with the Bracket and Shade Choices

The "Flexi Neck" Swing Arm Wall Light gives you control over where the light lands because of its brass goose neck and separate bracket. Before you start adjusting, note that you can choose the shade colour and bracket colour independently. The available combinations include Powder Coated Black, Powder Coated White, Brass, and mixed finishes such as a Brass bracket with a Powder Coated Black shade. This choice does not change the adjustment mechanics, but it lets you match the fixture to your wall finish.

The hand-spun Lulu shade is the same across all variants, so the aiming method stays consistent regardless of the colour you pick.

How to Adjust the Swing Arm and Shade

The goose neck is pure brass and bends to reposition the shade. The bracket mounts firmly to the wall and holds the arm steady once you set the angle. Follow these steps to aim the light for reading or ambient use.

  1. Loosen the goose neck gently: Hold the bracket with one hand and the neck with the other. The brass is soft enough to bend by hand but stiff enough to hold its position. Move the neck in small increments to avoid over-bending.
  2. Aim the shade toward your task area: For reading, direct the shade downward and slightly forward so the light pool hits the page or surface. For ambient light, angle the shade upward or toward a wall to create indirect illumination.
  3. Tighten the bracket if needed: The bracket holds the arm in place once you set the angle. If the arm drifts, check that the bracket screws are snug against the wall plate. The catalog does not specify torque values, so hand-tighten until the arm stays put without forcing.
  4. Test the position from your usual seat: Sit or stand where you will use the light most. Adjust the neck again if the beam falls too high or too low. Two lights on either side of a sofa, as the catalog suggests, work well when both are aimed toward the centre seating area.

What the Catalog Confirms About This Wall Light

  • "Flexi Neck" Swing Arm Wall Light - Bracketed: The pure brass goose neck and bracket allow you to position light at variable angles. This confirms you can aim the shade without tools or disassembly. The bending range is not specified, but the design is made for manual repositioning.

    "Flexi Neck" Swing Arm Wall Light - Bracketed

    "Flexi Neck" Swing Arm Wall Light - Bracketed

  • "Flexi Neck" Swing Arm Wall Light - Bracketed: Select your choice of shade and bracket colour in the options. You can order the light in a finish that matches your decor. The adjustment steps are identical for all colour variants.

  • "Flexi Neck" Swing Arm Wall Light - Bracketed: We Love: Two either side of living room sofa This placement works for symmetrical reading light or for framing a seating area. Aim each arm toward the centre for even coverage.

What the Supplied Record Does Not Settle

The catalog does not provide a maximum bend angle or a recommended distance from the wall. The goose neck is adjustable, but avoid sharp bends that could kink the brass. If you need a specific beam angle or reach measurement, test the position with the light temporarily mounted before finalising the location.

No electrical or wiring instructions are included in the supplied evidence. The adjustment guide assumes the light is already wired and mounted per local codes. For installation steps, refer to the product packaging or a qualified electrician.