Quick answer

Mount the Godox AD-R6 Standard Reflector by aligning its Bowens mount with the strobe’s three-lug mount, pressing it on, and turning until it locks. Then aim the 7-inch reflector and confirm the umbrella hole is clear before adding an umbrella.

Why the Bowens mount fit matters more than the reflector size

The AD-R6 uses the widely used Bowens mount, so it fits the Godox AD600B and AD600BM flash heads and other heads with the same mount. That compatibility is the main reason to choose it over a brand-specific reflector. A loose or misaligned mount changes the beam angle and can let the reflector shift mid-shoot, so check the lock before you raise the light.

When to use the umbrella hole and when to leave it capped

The AD-R6 has a specialized accessory hole for umbrellas. Use it when you want a shoot-through or reflective umbrella combined with the reflector’s spill control. Leave the hole clear only when an umbrella shaft is inserted; otherwise the opening lets light escape and softens the edge of the beam. If you do not need an umbrella, the reflector works on its own as an aluminum modifier.

How to mount and aim the AD-R6 step by step

  1. Check the strobe mount and remove any adapter: Confirm your strobe has a Bowens mount. Remove any speed ring or adapter that is not needed, then line up the reflector’s three tabs with the mount’s three slots. If the reflector does not sit flush, stop and check for a leftover adapter ring.
  2. Seat and lock the reflector: Press the reflector straight onto the mount and turn it clockwise until it clicks or the locking collar tightens. Gently pull the reflector to confirm it is secure. A reflector that turns past the stop or feels loose is not fully seated.
  3. Aim the beam before adding an umbrella: Set the strobe power low and use the modeling light if available. Aim the reflector at your subject and check the spread; the 7-inch size gives a tighter beam than a large softbox. Mark the floor position once the beam is centered so you can return to it.
  4. Insert an umbrella only through the accessory hole: If using an umbrella, slide the shaft through the hole in the reflector and tighten the umbrella’s own locking mechanism. Keep the shaft centered so it does not press against the flash tube. Never force an umbrella shaft through the reflector hole at an angle.
  5. Recheck the lock after the first few frames: After a test shot, confirm the reflector is still locked and the umbrella has not slipped. Re-tighten if needed before continuing. A reflector that shifts during a shoot changes your beam angle without warning.

Product facts