Why You Might Need a Trigger Output
When adding an aftermarket amplifier to a factory stereo, you often lose the simple remote turn-on wire that aftermarket head units provide. A line output converter (LOC) solves the signal conversion, but the remote turn-on for the amp still needs a 12V+ signal. The DS18 V5HL Hi/Lo Converter 5-Channel includes a 12 volt trigger output that senses audio signal and sends a remote turn-on voltage to your amplifier, eliminating the need to run a separate wire from the fuse box or ignition.
How the Trigger Output Works on the V5HL
The V5HL's remote trigger output with signal sensing monitors the high-level speaker inputs. When it detects an audio signal (meaning the factory stereo is on), it outputs a +12V signal on the remote output terminal. This connects directly to the remote input on your aftermarket amplifier. When you turn the factory stereo off, the trigger drops the signal, and the amplifier turns off automatically.
This feature is especially useful in vehicles where the factory radio does not have a dedicated remote turn-on wire, or where running a new wire through the firewall is difficult.
DS18 V5HL Key Specifications for Trigger Use
-
Hi/Lo Converter 5-Channel with 12 Volt Trigger Output (Remote out): Working Voltage: +12V The trigger output matches standard automotive electrical systems, so it works with most aftermarket amplifiers that expect a 12V remote signal.
Hi/Lo Converter 5-Channel with 12 Volt Trigger Output (Remote out)
-
Hi/Lo Converter 5-Channel with 12 Volt Trigger Output (Remote out): Remote Trigger Output with Signal Sensing This is the specific feature that provides the automatic turn-on/off without a dedicated remote wire from the head unit.
-
Hi/Lo Converter 5-Channel with 12 Volt Trigger Output (Remote out): Standby Current: 200 mA The converter draws minimal current when the system is off, so it won't drain your battery while waiting for a signal.
Connecting the Trigger Output Step by Step
- 1. Connect high-level inputs: Wire the V5HL's 4 high-level input channels to your factory speaker outputs. The converter senses audio signal from these wires.
- 2. Run power and ground: Connect the +12V and GND terminals to a constant 12V source and a clean chassis ground. The converter needs constant power to monitor the signal.
- 3. Connect the trigger output: Run a wire from the V5HL's remote trigger output terminal to the remote turn-on input on your aftermarket amplifier. No additional relay or switch is needed.
- 4. Connect RCA outputs: Use the 5-channel RCA output (4 full-range + 1 subwoofer) to feed your amplifier(s). The trigger output works independently of the RCA signal path.
- 5. Test the system: Turn on the factory stereo. The amplifier should power up automatically. Turn it off; the amplifier should shut down after a short delay. If not, check that the input signal is present and the trigger wire is secure.
When the Trigger Output Is Most Useful
The trigger output is ideal for factory systems that lack a dedicated remote wire, such as many OEM radios from the early 2000s or base-model trims. It also simplifies installations in vehicles where running a wire to the fuse box is impractical. If your factory radio already has a remote output, you can still use the V5HL as a standard LOC and ignore the trigger feature.
