Quick answer

Applying a center console vinyl wrap is a straightforward DIY project that protects your Tesla's scratch-prone surfaces and adds a custom look. Follow these steps for a smooth, bubble-free finish.

Why wrap your center console?

The original glossy piano black finish on early Model 3 and Model Y center consoles shows every fingerprint and micro-scratch. A vinyl wrap not only hides existing marks but prevents new ones, and it lets you change the interior color without permanent modification.

Choosing the right wrap

Make sure you have the correct wrap for your console generation. The 1st-gen console (shiny piano black) uses a different wrap than the 2nd-gen version. Check your console finish before ordering to avoid fit issues.

Step-by-step installation

  1. Clean the surface thoroughly: Wipe down the center console with a microfiber cloth and isopropyl alcohol to remove all dust, oils, and residue. Any debris left under the wrap will create bumps or prevent adhesion. A clean surface is essential for a bubble-free result.
  2. Dry-fit the wrap without removing backing: Hold the vinyl wrap over the console to align it with the edges and cutouts. Mark the position with tape if needed. This step prevents misalignment when you apply the adhesive. Skipping dry-fit often leads to crooked placement that is difficult to fix after sticking.
  3. Peel and apply from the center outward: Remove a small section of backing, align the wrap at the center, and press it down while slowly peeling the rest. Use a squeegee or credit card wrapped in a cloth to push air bubbles toward the edges. Work slowly — rushing causes wrinkles that are hard to smooth out.
  4. Heat and stretch around curves: Use a heat gun or hair dryer on low heat to warm the vinyl around tight corners and contours. The heat makes the material pliable so it conforms without lifting or creasing. Too much heat can shrink or damage the vinyl; keep the nozzle moving.
  5. Trim excess with a sharp blade: Once the wrap is fully adhered and cooled, use a fresh utility knife or hobby blade to trim any overhang along the edges. Cut at a shallow angle to avoid scratching the console plastic underneath. A dull blade can tear the vinyl or leave jagged edges.

Product facts

  • Center Console Vinyl Wrap for Model 3 & Y (Gen 1 Center Console): ⚠️ Please check before ordering: These are for the Model Year 2018-20 Model 3 (and SOME of 2021) and 2019-20 Y with the original '1st Gen' center console. If your center console is shiny Piano Black, then you have a 1st-gen version. Ordering the wrong generation wrap will not fit correctly, so verifying your console finish before purchase saves time and frustration.

    Center Console Vinyl Wrap for Model 3 & Y (Gen 1 Center Console)

    Center Console Vinyl Wrap for Model 3 & Y (Gen 1 Center Console)