Why Curl and Shape Lash Contour 371 Lashes
The Ardell Lash Contour 371 comes with a pre-formed angled, flared profile designed to create a cat-eye effect. Even with that intentional curve, a little personal shaping can help the lash band follow your natural lash line more closely, especially if your eyes are rounder or more almond-shaped than average.
Because the lashes are made with Ardell's Invisiband technology, the band is thin and flexible. That makes it easier to adjust the curve without damaging the fibers, but it also means the band can spring back to its original shape if you don't hold it in the new position long enough.
How to Adjust the Curve of Lash Contour 371
Work with clean, dry lashes and clean hands. The lash band is already flexible, so you won't need heat or special tools.
- Test the fit against your eye: Hold the lash strip up to your eyelid without glue. If the outer corner lifts away or the inner corner sits too high, the band needs a gentler curve.
- Gently coax the band: Using your fingers, press the middle of the band against a rounded surface (like your finger or a clean makeup brush handle) for a few seconds. The Invisiband material will take on a new shape as it cools in that position.
- Re-test and repeat: Place the lash against your eye again. If the curve still doesn't match, repeat the shaping step. Avoid bending the band sharply or pulling on the lash fibers.
Application Tips for a Secure Fit
The Lash Contour 371 includes a bottle of DUO Line It, Lash It adhesive that doubles as a dark eyeliner. Apply a thin layer along the band, wait until it becomes tacky, then press the band onto your lash line starting from the center. The angled flared profile naturally lifts the outer corner, so you don't need to over-manipulate the band.
If you prefer a clear adhesive, you can use your own lash glue. The supplied DUO adhesive is waterproof and latex-free, which may be a plus for sensitive skin.
Product Facts: Lash Contour 371
-
Lash Contour 371, 2-Pairs: Angled flared lash profile with intricately positioned, crisscross lash fibers for a dramatic, cat-eye look. The pre-shaped flare reduces the amount of manual curling needed, but you can still fine-tune the band curve for your eye shape.
Lash Contour 371, 2-Pairs
-
Lash Contour 371, 2-Pairs: Invisiband lash band technology – thin, flexible, and designed to feel comfortable and secure. The flexible band responds well to gentle shaping but can spring back if not held in the new position long enough.
-
Lash Contour 371, 2-Pairs: Includes 1 bottle of DUO Line It, Lash It adhesive that dries into a dark eyeliner. Waterproof, latex-free, and paraben-free. The built-in adhesive eliminates the need for separate glue and liner. If you prefer a clear bond, you can substitute your own adhesive.
What to Avoid When Shaping Lash Contour 371
Don't use heat (hair dryer, lighter, hot water) on the lash band. The Invisiband material is not designed for heat shaping, and heat can warp the crisscross fibers or weaken the adhesive bond.
Don't pull or stretch the band lengthwise. The band is meant to be trimmed from the outer corner if it's too long, not stretched to fit.
Don't curl the lashes after application. The pre-curled fibers hold their shape; using an eyelash curler on falsies can crush the crisscross pattern.
How to Store Your Lash Contour 371 for Long-Lasting Shape
After use, gently remove any remaining adhesive from the band with a makeup remover or oil-free cleanser. Place the lashes back in the original tray or a clean, curved surface to help them retain their shape. Storing them flat or crumpled can cause the band to lose its intended curve over time.
The Lash Contour 371 comes as a 2-pair pack, so you can rotate between pairs to extend the life of each set.



