Quick answer

Install your PALO 1G toggle light switch by first turning off power, then connecting the live, neutral, and earth wires to the module, and finally securing the switch plate. Choose the correct toggle type (two-way, intermediate, or retractive) for your circuit.

Why the toggle type matters before you start

The PALO 1G toggle switch is available in two-way, intermediate, and retractive versions. Two-way works for controlling a light from one or two points, intermediate for three or more, and retractive pairs with multiway or smart systems. Selecting the wrong type means the switch won't function as intended, so check your circuit requirements before buying.

Tools and safety prep

You'll need a voltage tester, screwdrivers (flathead and Phillips), wire strippers, and a small level. Always turn off the mains at the breaker and confirm zero voltage with your tester before touching any wires. Work on a dry, well-lit surface.

Installation steps

  1. 1. Turn off power and test: Switch off the circuit breaker supplying the switch. Use a voltage tester to confirm no current is present at the existing switch terminals. Double-check with a non-contact tester even if the breaker is off—wires can be mislabeled.
  2. 2. Remove the old switch plate: Unscrew the existing switch plate and pull it forward gently. Note the wire connections: live (brown/red), neutral (blue/black), and earth (green/yellow). Take a photo for reference. Label wires with tape if they aren't color-coded clearly—mixing them up is a common error.
  3. 3. Disconnect and prepare wires: Loosen the terminal screws on the old switch and remove each wire. Strip about 10mm of insulation from each wire end if needed. Twist stranded wires to prevent fraying. Avoid stripping too much insulation—exposed wire can short against the metal box.
  4. 4. Connect the PALO module: Attach the live wire to the COM terminal, the neutral to the L1 (or L2 for two-way), and the earth to the ground terminal. Tighten screws firmly but not overtighten. For two-way circuits, use the L1 and L2 terminals correctly; swapping them won't damage the switch but will reverse the on/off positions.
  5. 5. Mount the switch plate: Gently push the wired module back into the wall box, ensuring wires are not pinched. Align the brass toggle plate with the mounting holes and screw it in place. Use a small level to check it's straight. Over-tightening the screws can crack the brass plate or strip the threads—snug is enough.
  6. 6. Restore power and test: Turn the breaker back on. Flip the toggle to verify the light turns on and off correctly. If using a two-way setup, test from both switch positions. If the switch feels loose or the toggle doesn't click firmly, turn off power and recheck the module seating.

Product details

  • PALO 1G Toggle Light Switch - Brass: The toggle is turned from solid brass for a considered flick and a genuinely satisfying click. This solid brass construction gives the switch a premium feel and durability that plastic toggles lack, making the daily action more satisfying.

    PALO 1G Toggle Light Switch - Brass

    PALO 1G Toggle Light Switch - Brass