Quick Answer

To install agility equipment stakes, first position the equipment on level ground, then drive the stake through the anchor hole at a slight angle, and finally test the stability before training.

Why Staking Matters for Safety

Agility equipment like see-saw teeters and walks can shift or tip during intense training, especially on soft ground. Stakes anchor these pieces firmly, reducing the risk of injury to your dog and extending the life of your equipment.

Staking is especially important for outdoor training where wind, uneven terrain, or a powerful dog can move equipment. Taking a few extra minutes to secure everything properly makes each session safer and more effective.

Choosing the Right Stakes

Not all stakes are the same. The Agility 7" Equipment Stakes from ActiveDogs are designed specifically for agility gear. They measure 7 inches long and fit holes of 3/16 inch or larger, making them compatible with most teeters and walks.

These stakes are lightweight yet sturdy, so they're easy to start into the ground while still providing solid anchoring. If your equipment has smaller holes, you'll need to check the diameter before purchasing.

Step-by-Step Installation Guide

  1. Position the Equipment: Place the agility equipment on level ground where you want it. Make sure the anchor hole is accessible and the equipment is stable before you start. Check that the ground is firm and free of rocks that could bend the stake.
  2. Insert the Stake: Hold the stake perpendicular to the ground and start it through the anchor hole. Use your foot or a mallet to drive it in, keeping it straight. Drive the stake at a slight angle if the ground is hard—this increases holding power.
  3. Test Stability: Once the stake is fully in the ground, try to wiggle the equipment. It should not move more than a fraction of an inch. If it does, drive the stake deeper or add a second stake. Always test the setup before letting your dog on the equipment.

  • Agility 7" Equipment Stakes: The Agility 7" Equipment Stakes are 7 inches long and fit holes of 3/16 inch or larger. This size works with most standard agility equipment, so you can secure teeters and walks without needing to modify your gear.

    Agility 7" Equipment Stakes

    Agility 7" Equipment Stakes