Quick answer
Install low profile mud flaps on your Model 3 in about 20 minutes using the included screwless clips and tools—no drilling, no permanent changes.
Why screwless mud flaps are worth it
Most mud flaps require drilling into your fender liner or using screws that can strip or rust. The screwless design here uses clips that attach to the existing liner, so everything stays reversible. That matters if you lease your Model 3 or just want the option to remove them later without leaving holes.
The low profile look is similar to what Tesla sells for the Model Y, but this set covers all four wheels—Tesla only sells a front set. That means your rear wheels get the same protection, which is where most road spray kicks up.
What you get in the box
Each set ships with all four mud flaps (front and rear) plus the clips and tools needed for installation. You don't need to buy anything extra—just a clean car and a few minutes.
Step-by-step installation
- Prepare your car: Park on a flat surface and clean the area behind each wheel where the flap will sit. Dirt and grime can prevent the clips from seating flush. A clean surface ensures a secure fit and avoids scratching the paint.
- Dry-fit the flap: Hold the mud flap up to the fender liner to confirm it aligns with the existing holes or clip points. Do not force it—if it doesn't sit flush, reposition. If it doesn't align, check that you're using the correct flap for that wheel position.
- Attach the clips: Insert the provided clips into the liner holes, then press the flap onto the clips. Make sure each clip clicks into place. A common mistake is pushing only one side, which can cause the flap to hang unevenly. Press evenly on all clips to ensure a snug, level fit.
- Test and adjust: Gently tug the flap to ensure it's secure. If it moves, remove and re-seat the clips. Then turn the steering wheel to full lock in both directions to confirm the flap doesn't rub against the tire. A quick test drive at low speed will confirm there's no rubbing or noise.
Product facts
-
Low Profile Mud Flaps for Model 3: Screwless design with all required tools included, making installation fully reversible. You can install without drilling or permanent modifications, and remove them cleanly if you sell or return your lease.
Low Profile Mud Flaps for Model 3