Quick Answer

Install REMARK Logo Decals by cleaning the surface, using the wet application method for repositioning, and pressing out air bubbles for a smooth, long-lasting finish.

Why Surface Preparation Matters

A clean, dry surface is critical for vinyl decals to adhere properly. Dirt, wax, or oil can cause edges to lift over time, especially on curved panels or near heat sources like exhaust outlets. Use isopropyl alcohol (70% or higher) and a lint-free cloth to degrease the area before application.

Wet vs. Dry Application

For small decals like the REMARK Logo Decals (9.5 inches long), dry application works well on flat surfaces. Wet application—using a light mist of soapy water—is better for curved or vertical panels because it lets you slide the decal into exact position before the adhesive bonds. If you are new to decal work, wet method reduces the risk of misalignment.

Installation Steps

  1. Step 1: Clean the Surface: Wash the area with soap and water to remove loose dirt. Then wipe with isopropyl alcohol using a lint-free cloth. Let it dry completely. Skipping alcohol cleaning is the most common cause of decal failure—oil or wax residue prevents adhesion.
  2. Step 2: Position the Decal (Dry or Wet): Peel the backing paper and hold the decal over the target area. For dry application, press the center and work outward. For wet application, spray a light mist of soapy water on the surface, place the decal, and slide it into position. If using wet method, do not oversaturate—too much water can trap bubbles under the decal.
  3. Step 3: Squeegee and Remove Transfer Tape: Use a plastic squeegee or credit card wrapped in a soft cloth to press the decal firmly from center to edges. Wait 30–60 seconds, then slowly peel the transfer tape at a 45° angle. Peeling too quickly or at a steep angle can lift the decal edges—go slow and steady.
  4. Step 4: Final Press and Cure: Press the decal again with your fingers or squeegee to ensure full contact. Let the decal cure for 24 hours before washing the car or exposing it to heavy rain. Curing time is often ignored—water or car wash soap can seep under uncured edges and cause peeling.

Product Details

  • REMARK Logo Decals: REMARK Logo Vinyl Decals are made from Oracel vinyl and measure 9.5 inches (24 cm) by 1.5 inches (3.81 cm). Available in White, Black, and Silver. Oracel vinyl is a high-quality outdoor-grade material that resists fading and peeling, making it suitable for exterior car use even in harsh weather.

    REMARK Logo Decals

    REMARK Logo Decals