Before You Start: Know Your Brake System

Shimano disc brake pads are designed for specific brake calipers. Using the correct pad model ensures proper fit, braking performance, and safety. The Shimano G02A Resin Disc Brake Pads, for example, are compatible with a wide range of Shimano brake systems including BR-M9000, BR-M9020, BR-M8000, BR-M985, BR-M785, BR-M666, BR-S700, BR-R785, and BR-RS785. Always check your caliper model before purchasing replacement pads.

Resin pads like the G02A offer quiet, consistent braking and are a popular choice for cross-country and trail riding. They are not confirmed for use with other brake brands, so stick with genuine Shimano pads for your Shimano system.

Step-by-Step Installation

These steps are based on the supplied information for Shimano disc brake pads. Always refer to the manufacturer's instructions for your specific caliper model.

  1. 1. Remove the wheel and old pads: Take the wheel off your bike to access the brake caliper. Remove the retaining clip or pin that holds the pads in place. Slide out the old pads and note how the spring sits between them.
  2. 2. Insert the new pads and spring: Place the new Shimano G02A resin pads into the caliper with the friction material facing the rotor. Install the spring between the pads as it was in the original setup. Press the pads into the caliper until they seat fully.
  3. 3. Secure the pads: Reinstall the retaining clip or pin that came with your caliper. Ensure it is fully engaged to prevent the pads from moving during riding.
  4. 4. Reset the piston(s): If the caliper pistons are extended, use a plastic tire lever or a dedicated tool to gently push them back flush. This creates space for the new, thicker pads. Avoid damaging the piston seals.
  5. 5. Reinstall the wheel and bed in the pads: Put the wheel back on and spin it to check for rotor rub. If the pads drag, adjust the caliper alignment. Finally, perform a series of gentle stops to bed in the new pads—this helps the resin material mate with the rotor for optimal braking.

Shimano G02A Resin Pad Compatibility

  • Shimano BR-M9000 Disc Brake Pads G02A Resin: Genuine Shimano disc brake pads for use with Shimano brake systems. Can be used on BR-M9000, BR-M9020, BR-M8000, BR-M985, BR-M785, BR-M666, BR-S700, BR-R785, and BR-RS785. Verifying compatibility with your caliper model ensures the pads fit correctly and function safely. Using the wrong pad can lead to poor braking or damage.

    Shimano BR-M9000 Disc Brake Pads G02A Resin

    Shimano BR-M9000 Disc Brake Pads G02A Resin

Tips for a Smooth Installation

Work on a clean surface to avoid contaminating the pads with oil or dirt. If your brake system uses a pad spreader spring, make sure it is oriented correctly—the spring legs usually face the caliper body. After installation, pump the brake lever a few times to bring the pads into contact with the rotor before riding. Resin pads generally require less effort to bed in than sintered pads, but always follow the guidance that came with your brake system.

If you notice squealing or reduced braking power after installation, the pads may need more bedding-in or the rotor could be contaminated. Cleaning the rotor with isopropyl alcohol and repeating the bedding process often resolves these issues.