Quick answer
Install the Trunk Handles for Refreshed Model Y (Juniper) by cleaning the trunk surfaces, positioning each handle over its compartment, and pressing firmly to activate the Velcro strips for a secure, factory-like fit.
Why add trunk handles to your Juniper
The refreshed Model Y (Juniper) has a two-section trunk: a main lower area and a shallower compartment. Lifting these panels without a handle can be awkward, especially when your hands are full. The slip-on handles give you a natural grip point, making it easier to access the space below.
Because they are designed specifically for the Juniper, the handles match the interior contours and look like they came from the factory. They are sold as a set of two, so you can cover both trunk sections without mixing and matching.
What to expect during installation
Installation is straightforward and requires no tools. The handles simply push into place and use Velcro strips to stay secure. The whole process takes about five minutes, but proper surface prep is key to a lasting hold.
One trade-off to note: the Velcro relies on a clean, dry surface. If you install the handles on a dusty or greasy trunk, they may not stay put. A quick wipe with a microfiber cloth solves this.
Installation steps
- Clean the trunk surfaces: Use a dry microfiber cloth to wipe the edges of both trunk compartments where the handles will sit. Remove any dust, dirt, or moisture. Check that the surface feels smooth and dry before moving on.
- Position the handle on the main trunk: Take the handle for the lower trunk and align it over the edge of the main compartment. Press it into place, ensuring it sits flush against the panel. Make sure the handle is centered and not twisted before pressing down.
- Secure the handle with Velcro: Press firmly along the entire length of the handle to activate the Velcro strips. Apply steady pressure for a few seconds to ensure a strong bond. If the handle feels loose, lift it off, clean the area again, and re-press.
- Repeat for the shallower compartment: Install the second handle on the shallow trunk section using the same process: clean, position, and press firmly. Test both handles by lifting each panel to confirm they are secure.
Product facts
-
Trunk Handles for Refreshed Model Y (Juniper): These slip-on handles are sold as a set of two, one for the main lower trunk and one for the shallower trunk compartment. You get complete coverage for both trunk sections, so you don't have to buy additional pieces.
Trunk Handles for Refreshed Model Y (Juniper)