Quick answer
To refill a refillable floss container, open the dispenser, drop in a fresh bobbin, thread the tail through the cap hole, and close it. Then pull a short length to seat the floss and cut it. The Natural Floss Refill from Better & Better includes two bobbins and is designed for roughly 120 uses, so one refill pack can last months. The most common mistake is over-pulling during threading, which causes tangles and wasted floss.
Why refilling your floss dispenser saves money and waste
A refillable floss container is designed to be kept, not tossed. When you buy a natural floss refill, you are paying for the floss itself, not new plastic housing. That lowers the cost per use and keeps disposable dispensers out of the waste stream. It also means you can keep a floss container that already fits your hand and your bathroom routine.
What you need before you start
Gather your empty or nearly empty dispenser, a fresh floss bobbin, and a small pair of scissors or nail clippers. Work over a counter or a tray so that if the bobbin slips, it does not roll onto the floor. If your dispenser has a lid or cap, set it aside where you can see it. A clean, dry surface matters because floss can pick up dust or grit that later feels rough between teeth.
How to load the bobbin and thread the cap
Open the dispenser according to its design. Most refillable models either unscrew or pop open at the middle. Remove the empty bobbin and set it aside for recycling if your local program accepts it. Drop the new bobbin into the holder so it sits flat and can spin freely. Then take the loose tail of floss and pass it through the small hole in the cap or lid. This is the step where tangles happen, so pull only enough floss to reach through the hole, about two to three inches. If the tail will not go through, do not force it; check for a burr or a bit of old floss blocking the hole, and clear it with a toothpick.
Step-by-step floss refill instructions
- Open the dispenser and remove the empty bobbin: Unscrew or pop open your refillable floss container. Take out the spent bobbin and set it aside. Wipe the inside with a dry cloth if you see dust or floss fragments. Checkpoint: the bobbin holder should be clean and dry before you add a new bobbin.
- Insert the new bobbin: Drop the fresh bobbin into the holder so it sits flat and can rotate. Do not force it; if it does not sit flush, rotate it until it drops into place. Mistake to avoid: putting the bobbin in at an angle, which makes the floss drag and fray as you pull.
- Thread the tail through the cap hole: Pull about two to three inches of floss from the bobbin and push it through the small hole in the cap or lid. Use a gentle twisting motion if the hole is tight. Checkpoint: if the floss will not pass through, clear the hole with a toothpick rather than pulling harder.
- Close the dispenser and pull a short test length: Snap or screw the cap back on. Pull a short length of floss, about six inches, to make sure it feeds smoothly and the bobbin spins. Cut that test length off and discard it. Mistake to avoid: pulling a long strand to test. That wastes floss and can cause the bobbin to over-spin and tangle.
- Cut and store for daily use: Cut the floss to your usual length, or leave the tail ready to pull. Close the cap and store the dispenser upright or on its side, wherever it stays clean and dry. Next step: floss as usual, and when the bobbin runs out, repeat these steps with the second bobbin from your refill pack.
Product facts
- Natural Floss Refill: Natural Floss Refill includes two bobbins of floss and is made to last for approximately 120 uses. Two bobbins give you a long supply, so you can refill your dispenser multiple times before reordering. The 120-use estimate helps you plan how often to replace the bobbin based on your daily flossing habit.