What a Spiral Screw Extractor Does

A spiral screw extractor is a tool designed to remove broken bolts, stripped screws, and damaged fasteners that won't turn with a normal screwdriver or wrench. The extractor has left-hand spiral flutes that bite into the fastener as you turn it counterclockwise, allowing you to back out the stuck piece.

The Drill Hog® Jumbo #7 Spiral Easy Out Screw Extractor is built for larger fasteners. It removes screws from 7/8" to 1-1/8" and can also handle 1/2" pipe. The extractor is made from HI-Molybdenum M7 steel, a tough alloy that resists breaking under the torque needed for stubborn bolts.

How to Use the #7 Spiral Screw Extractor

The following steps are based on the supplied specifications for the Drill Hog® #7 Spiral Easy Out. Always follow the manufacturer's instructions for your specific extractor and drill.

  1. 1. Drill a pilot hole: Drill a centered hole into the broken bolt. Drill Hog recommends using a 17/32" drill bit for the #7 extractor. The hole gives the spiral flutes a surface to grip.
  2. 2. Insert the extractor: Tap the #7 spiral easy out into the pilot hole. The left-hand spiral flutes will engage the metal as you turn.
  3. 3. Turn counterclockwise: Use a wrench on the 4 flat sides of the shank. The flat shank design prevents the extractor from spinning in the chuck and allows you to apply steady torque. Turn counterclockwise to back out the broken bolt.
  4. 4. Remove the fastener: Once the extractor bites, continue turning until the bolt comes free. If the bolt is very tight, apply penetrating oil and let it sit before trying again.

Choosing the Right Extractor Size

The #7 extractor is designed for screws 7/8" to 1-1/8" in diameter and for 1/2" pipe. Using the correct size ensures the spiral flutes have enough contact to grip without slipping. A too-small extractor may snap, while a too-large one may not fit the pilot hole.

The supplied information does not include operating speeds for the drill or torque limits for the extractor. For best results, work slowly and apply steady pressure rather than high speed or sudden force.

Product Facts: #7 Spiral Easy Out Screw Extractor

Trade-offs and Tips

Spiral extractors work best on bolts that are not rusted solid. For severely corroded fasteners, consider applying penetrating oil and letting it soak overnight before attempting extraction.

The left-hand spiral design means the extractor tightens its grip as you turn counterclockwise, which is the same direction you turn to remove a bolt. This is an advantage over straight-flute extractors that can slip.

If the bolt is flush with the surface, you may need to center-punch it before drilling the pilot hole to keep the drill bit from wandering. The supplied information does not cover this step, but it is a common practice for accurate drilling.