What the AS-PF Pre Filter Does
The B-Air AS-PF Stage 1 pre filter is the first line of defense in your AS-550 or RA-650 air scrubber. It captures the largest airborne particles before they reach the higher-efficiency filters inside the machine. This synthetic fiber filter media is rated at 10% efficiency and is designed to be replaced regularly to keep the scrubber working at full capacity.
Because the pre filter traps coarse debris first, it extends the life of the more expensive internal filters. Changing it on schedule is the single most important maintenance step for these air scrubbers.
B-Air AS-PF Pre Filter at a Glance
-
B-Air AS-PF Stage 1 Air Scrubber Pre Filters: 5 pack: First Stage Pre-Filter Restore your AS-550 or RA-650 to maximum capacity. A clogged pre filter reduces airflow and scrubbing efficiency. Replacing it restores the machine's designed performance.
B-Air AS-PF Stage 1 Air Scrubber Pre Filters: 5 pack
-
B-Air AS-PF Stage 1 Air Scrubber Pre Filters: 5 pack: Synthetic fiber filter media rated at 10% efficiency. This pre filter is not a HEPA filter; it catches large particles so the downstream filters can focus on finer contaminants.
-
B-Air AS-PF Stage 1 Air Scrubber Pre Filters: 5 pack: Captures the largest particles to help extend the life of the higher efficiency filters inside. Regular pre filter changes reduce how often you need to replace the more expensive main filter.
-
B-Air AS-PF Stage 1 Air Scrubber Pre Filters: 5 pack: Replace regularly to ensure maximum performance. The manufacturer recommends routine replacement, but the exact interval depends on usage and air quality conditions.
How to Replace the Pre Filter
The replacement process itself is straightforward. The AS-PF pre filter is designed to slide into the first stage of the AS-550 or RA-650 air scrubber. Below are the general steps based on the supplied information.
- Turn off and unplug the air scrubber: Always disconnect power before accessing the filter compartment to avoid accidental startup.
- Open the pre filter access panel or door: Locate the latch or release on the front or side of the unit. The exact mechanism may vary by model.
- Remove the old pre filter: Slide out the used synthetic fiber filter. Dispose of it according to local regulations.
- Insert the new B-Air AS-PF pre filter: Align the new filter with the slot and push it fully into place until it sits flush. The fiber media is oriented to catch particles on the intake side.
- Close and secure the access panel: Make sure the door or cover is fully closed and latched before plugging the scrubber back in.
- Restore power and verify operation: Plug the unit in and run it briefly to confirm airflow returns to normal and there are no unusual sounds.
When to Replace the Pre Filter
The supplied information states that the pre filter should be replaced regularly to ensure maximum performance, but it does not specify a fixed schedule. In practice, check the filter visually every few weeks. If it appears heavily loaded with dust or debris, it is time for a change. Heavy-duty use in construction, renovation, or high-dust environments will require more frequent replacement than light residential use.
A good rule of thumb is to replace the pre filter whenever you notice a drop in airflow or the machine seems to be working harder. This protects the main filter and keeps the scrubber running efficiently.
