What the AP-1.5 Kit Includes
The AllPondSolutions AP-1.5 is a compact 90L/H air pump designed for smaller tanks. It provides enough airflow to drive under-gravel filters, box filters, air stones, and protein skimmers that use ceramic air stones. The complete kit includes the pump, a free air stone (A-001, 25 x 12mm), 2 meters of 6mm air hose, a non-return valve, and a flow controller. A 180cm power cable is also attached.
Setting Up the AP-1.5 Air Pump
- Position the pump above the water level: Place the pump above the aquarium water line to prevent water from flowing back into the pump. If you cannot place it above the tank, fit the included non-return valve into the air line to stop backflow.
- Attach the air hose and non-return valve: Connect the 2m length of 6mm air hose to the pump outlet. If using the non-return valve, insert it into the hose between the pump and the air stone, ensuring the arrow on the valve points toward the air stone.
- Connect the air stone: Attach the supplied air stone (25 x 12mm) to the free end of the hose. For protein skimmers or other equipment that uses ceramic air stones, connect the hose directly to the device's inlet.
- Adjust airflow with the flow controller: Use the flow controller on the hose to fine-tune the amount of air entering the tank. Start with a low setting and increase gradually until you see gentle, even bubbles.
- Plug in and test: Plug the 180cm cable into a standard outlet. The pump operates at low frequency for quiet, continuous use. Check that bubbles are rising steadily and that no water is creeping back toward the pump.
AP-1.5 Specifications at a Glance
-
90L/H Aquarium Air Pump Complete Kit AP-1.5: Output: 90L/H – enough for under-gravel filters, box filters, air stones, and protein skimmers using ceramic air stones. This confirms the pump is suited for small to medium aquariums and compatible with common aeration devices.
90L/H Aquarium Air Pump Complete Kit AP-1.5
-
90L/H Aquarium Air Pump Complete Kit AP-1.5: Includes: 1 free air stone (25 x 12mm), 2m of 6mm air hose, 1 non-return valve, and a flow controller. You have everything needed for a basic setup right out of the box – no extra purchases required.
-
90L/H Aquarium Air Pump Complete Kit AP-1.5: Cable length: 180cm. The cable is long enough to reach most nearby outlets, but you may need an extension cord if the outlet is far from the tank.
Placement and Noise Tips
For quiet operation, place the pump on a soft surface (like a cloth or foam pad) to absorb vibrations. Keep it above water level to avoid backflow issues. The low-frequency design helps it run continuously without disturbing your tank's inhabitants.



