Quick answer
Set up your FT-801 X-style electric lifting table by unpacking, assembling the base, mounting the tabletop, wiring the controls, and performing a full safety test before use.
What makes the FT-801 different
The FT-801 uses an X-style lift mechanism powered by an electric motor, not a hydraulic pump. This design eliminates the need for oil changes and reduces the risk of leaks, but it requires careful alignment of the scissor arms during assembly to avoid binding.
Because the table can lower to 10 inches and rise to 41 inches, you have a wide range of working heights. The 300-pound capacity is generous, but the tabletop weight and the included drawer and hooks add to the load, so always distribute the pet's weight evenly.
Setup steps
- Unpack and inspect: Remove all parts from the box. Verify you have the tabletop, base frame, X-style lift arms, motor unit, foot pedal, hardware kit, and the drawer. Check for visible damage or missing bolts before starting assembly. Common mistake: skipping the inventory check leads to mid-assembly delays.
- Assemble the base frame: Lay the base frame on a flat surface. Attach the four leveling feet using the supplied bolts. Do not tighten fully yet — you will adjust them later for uneven floors. Checkpoint: ensure the frame sits square and the leveling feet are threaded evenly.
- Mount the X-style lift arms: Identify the left and right scissor arms. Connect each arm to the base pivot points using the heavy-duty pins. Cross the arms at the center and secure the center pin. Lubricate the pivot points with the included grease. Common mistake: reversing the arms causes binding. The arms must cross with the motor bracket facing the rear.
- Install the motor and foot pedal: Bolt the motor unit to the cross bracket on the lift arms. Route the power cable through the cable management channel on the base. Connect the foot pedal wire to the motor control box. Plug the motor into a grounded outlet. Checkpoint: the foot pedal must sit flat on the floor. If it rocks, adjust the base leveling feet.
- Attach the tabletop and accessories: Place the tabletop onto the lift arms. Secure it with the provided bolts through the mounting brackets. Install the drawer by sliding it into the front rail. Hang the towel hooks on the rear bar. Common mistake: over-tightening the tabletop bolts can strip the threads. Use hand-tight plus a quarter turn.
- Perform a full range test: Raise and lower the table three times through its full range. Listen for grinding or binding. Check that the table stops at 10 inches and 41 inches. Verify the foot pedal responds smoothly and the table holds position when you release it. Final checkpoint: if the table drifts down, tighten the motor brake adjustment screw (see manual). Do not use the table until it holds steady.
Product facts
-
FT-801 X-style Electric lifting table: The Aeolus FT-801 PRO Low-Low Electric Grooming Table has a lifting range from 10" to 41" and a 300lb capacity. You can groom large dogs at a comfortable height and lower the table for small or anxious pets, reducing strain on your back.
FT-801 X-style Electric lifting table