Quick Answer

To use a dragon ceramics waterfall incense burner, light a backflow incense cone, place it on the top opening, and let the smoke cascade down like a waterfall. For best results, use the burner in a still room and keep the smoke path clear.

Why Backflow Cones Are Essential

A dragon waterfall incense burner is designed to work with backflow incense cones, not regular cones or sticks. Backflow cones have a hollow bottom that creates a downward smoke flow, which is what makes the waterfall effect possible. Using a regular cone will only produce upward smoke and no cascade.

The Dragon Ceramics Waterfall Incense Burner (11CMx9.5CMx18.7CM) is made for this purpose. Its ceramic body and thick smoke flow mimic the sight of a tranquil waterfall, so choosing the right cone is the first step to getting that effect.

Common Mistakes That Break the Smoke Flow

Even with the right cone, the waterfall effect can fail if the room is drafty, the cone isn't lit properly, or the smoke path is blocked. A gentle breeze scatters the smoke before it can descend. Also, if you don't let the cone burn for a few seconds before placing it, the smoke may be too thin to flow downward.

Another frequent issue is placing the cone too deep or at an angle, which can block the internal channel. Always set the cone squarely on the designated spot and check that the hole at the bottom of the cone is aligned with the burner's opening.

Step-by-Step Setup and Use

  1. Choose a Stable, Draft-Free Spot: Place the dragon burner on a flat, heat-resistant surface away from windows, fans, or air vents. A still room is key for a steady downward smoke flow. If the smoke rises or drifts sideways, move the burner to a calmer location.
  2. Light the Backflow Cone Properly: Hold a backflow incense cone at a slight angle and light the tip. Let it flame for about 5 seconds, then blow it out. You should see a thin ribbon of smoke rising from the cone. If the smoke is weak, the cone may not be fully lit; relight and wait a few more seconds.
  3. Place the Cone on the Burner's Top Opening: Set the cone gently on the designated spot at the top of the dragon burner, ensuring the hole at the bottom of the cone aligns with the burner's smoke channel. Do not push it down hard. A misaligned cone blocks the smoke path and stops the waterfall effect.
  4. Wait for the Waterfall Effect: Give the smoke 30-60 seconds to build. You should see a thick stream that flows down the ceramic surface like water. If not, check for drafts or cone alignment. Patience is key; the effect takes a few moments to start.
  5. Extinguish and Clean After Each Use: When done, snuff out the cone by dipping it in water or using a snuffer. Let the burner cool completely, then wipe away ash with a dry cloth. Do not submerge the ceramic in water. Regular cleaning prevents residue buildup that can clog the smoke channel.

Product Facts