Quick answer

Choose a cover that matches your pack's volume range, attach it before you need it, and store it loosely rolled in a dry place. For added camouflage, use the laser-cut scrim to tuck in natural vegetation. Always test the fit with your pack fully loaded.

A backpack cover does more than keep rain out—it can also break up your silhouette in the field. The Savotta Backpack camo scrim, 40-80L is designed for both: it shields your gear from weather and adds a 3D camouflage layer that accepts natural vegetation.

Backpack camo scrim, 40-80L

Backpack camo scrim, 40-80L

This guide walks you through sizing, attachment, IRR considerations, and storage so you can get the most from your cover without overcomplicating it. Whether you're using a rain cover for a tactical backpack or a simple daypack, the steps below apply.

Step 1: Match the cover to your pack's volume

Start by checking your backpack's total volume in litres. The Savotta Backpack camo scrim, 40-80L fits packs from 40 to 80 litres, but you can cut it down to fit smaller packs. If your pack is at the lower end of that range, you'll have excess material that can be trimmed for a cleaner fit.

A common mistake is buying a cover that's too small. A cover that's stretched tight is harder to put on, wears faster, and may not fully protect your pack. When in doubt, size up and trim if needed.

  • Check your pack's volume in litres—usually printed on the pack or in its specs.
  • If your pack is under 40L, consider whether you want to cut the cover to size.

Step 2: Attach the cover correctly

Put the cover on your pack before you load it, or at least before you tighten all the compression straps. This makes it easier to pull the cover over the top and around the sides. The Savotta cover uses a simple design that stays in place once adjusted.

Make sure the cover doesn't block access to pockets or straps you need while hiking. If it does, adjust the cover's position or trim it. For packs with side pouches, like the Vertical pouch L, check that the cover doesn't interfere with zipper access.

  • Attach the cover before tightening compression straps to avoid pinching.
  • Test access to your side pouch or hip belt after fitting.

Step 3: Use the IRR and camouflage features

The Savotta Backpack camo scrim, 40-80L is made from laser-cut 500D Cordura, which is strong enough to safely hold natural vegetation. This lets you add local foliage to improve your camouflage. The 3D cut also breaks up the shape and silhouette of your pack.

An IRR backpack cover reduces infrared signature, but remember that adding natural vegetation can affect that. Use the cover's color as a base and add vegetation sparingly for the best effect. Always check local regulations regarding camouflage use.

  • Use the laser-cut loops to tuck in vegetation securely.
  • Don't overload the cover with vegetation—it can affect the fit and IRR properties.

Step 4: Store the cover properly

When not in use, roll the cover loosely and store it in a dry, ventilated place. Avoid folding it tightly for long periods, as creases can weaken the material over time. A simple stuff sack or a dedicated organizer works well.

Before storing, check for dirt or moisture. Wipe it clean with a damp cloth and let it dry completely. If you notice damage like a broken buckle or a small hole, Savotta's Gear care service can repair minor issues to keep your cover field-ready.

  • Never store a wet cover—mildew can damage the fabric.
  • Use a repair service for small damages instead of replacing the cover.

Step-by-step cover routine

  1. Check pack volume: Confirm your pack is between 40 and 80 litres. If smaller, plan to trim the cover. Checkpoint: cover should cover the pack without excessive slack.
  2. Attach before loading: Put the cover on before tightening straps to avoid pinching and ensure full coverage. Checkpoint: cover stays in place when pack is lifted.
  3. Add vegetation if needed: Use laser-cut loops to add local foliage for camouflage. Keep it light to maintain IRR properties. Checkpoint: vegetation is secure and doesn't obstruct movement.
  4. Store dry and loose: Roll loosely and store in a dry place. Clean and dry before storage. Checkpoint: no folds or moisture when stored.

Product facts

  • Backpack camo scrim, 40-80L: Laser cut 3D camouflage scrim cover for 40-80 litre backpacks. Breaks up shape and silhouette and allows adding natural vegetation and other camouflage material. Easy to adjust and cut into shape to fit smaller packs. Laser cut 500D Cordura is strong enough to safely allow adding of natural vegetation to further improve the camouflage effect. This cover fits a wide range of pack sizes and can be customized. The durable Cordura supports adding vegetation without tearing.
  • Vertical pouch L: A simple 6 litre general purpose zipper closure utility pouch with PALS compatible attachment system. Primarily designed for use with backpacks. If you use this pouch on your pack, ensure the cover doesn't block access to its zipper. You may need to adjust the cover's position.
  • Gear care service: Is your backpack broken or equipment damaged? With the help of Savotta's Gear care service, you can get your equipment back to field-ready condition. The service is intended for minor damage that can be repaired, such as a broken buckle or zipper, a hole or a broken seam. Instead of replacing a damaged cover, you can repair it for a fraction of the cost, extending its life.

Using a Savotta backpack cover is straightforward once you know the steps. Match the size, attach it properly, use the camouflage features wisely, and store it with care. With a little practice, your cover will protect your pack and keep you concealed in the field.