Quick answer
Always spot-clean your cooling dog bed memory foam insert; never submerge it in water. Use a mild detergent, cold water, and air dry completely to protect the Outlast temperature-regulating technology and orthopaedic base.
Why memory foam needs different care
Memory foam is porous and absorbs moisture, which can lead to mold, mildew, and permanent loss of support if soaked. The Cooling Orthopaedic Mattress from Dazy Dog also contains Outlast technology embedded in the fabric—submerging the insert can wash out or damage this phase-change material that helps regulate your dog's temperature.
Spot-cleaning preserves the foam's structure and the cooling function. For deeper cleaning, remove the cover (if machine-washable) and treat the insert separately with minimal moisture.
When to wash vs. when to replace
Wash the insert every 2–3 months or when there are visible stains or odors. If the foam has yellowed, lost its shape, or developed a persistent smell after cleaning, it's time to replace the insert. Most memory foam dog beds last 2–3 years with proper care.
How to wash a cooling dog bed memory foam insert
- Remove and wash the cover separately: Unzip and take off the cover. Machine wash it on a gentle cycle with mild detergent and cold water. Tumble dry on low or air dry. Check the cover's care tag; some covers can be machine dried, but the insert must never go in a dryer.
- Vacuum the foam surface: Use a handheld vacuum with a soft brush attachment to remove loose hair, dirt, and dander from the foam insert. Vacuuming first prevents you from rubbing debris deeper into the foam during spot-cleaning.
- Prepare a mild cleaning solution: Mix a few drops of mild liquid detergent (like baby shampoo or a wool-safe soap) with cold water in a spray bottle. Avoid bleach, fabric softener, or enzyme cleaners. Harsh chemicals can break down memory foam and reduce the effectiveness of Outlast technology.
- Spot-clean stains with a damp cloth: Lightly spray the cleaning solution onto a clean white cloth, not directly onto the foam. Blot the stained area gently—do not rub or scrub. Use a second damp cloth with plain water to rinse. Rubbing can damage the foam cell structure and create permanent indentations.
- Remove excess moisture: Press a dry towel firmly onto the cleaned area to absorb as much moisture as possible. Repeat with a fresh towel until the spot feels just slightly damp. Leaving excess moisture inside the foam creates a breeding ground for mold and mildew.
- Air dry completely before reassembling: Place the foam insert in a well-ventilated area away from direct sunlight and heat sources. Allow 24–48 hours for full drying. Flip it halfway through to speed up the process. Do not use a hairdryer, radiator, or fan heater—high heat can warp memory foam and degrade Outlast technology.
- Reassemble and rotate: Once the foam is completely dry, put the clean cover back on. Rotate the insert 180 degrees to promote even wear. Rotating every few months extends the life of the orthopaedic support and cooling layer.
Product facts
-
Cooling Orthopaedic Mattress - Midnight: The Cooling Orthopaedic Mattress uses Outlast technology, first developed for NASA spacesuits, to draw heat away and regulate temperature. This advanced material can be damaged by soaking, so spot-cleaning is essential to maintain the cooling performance your dog relies on for comfortable rest.
Cooling Orthopaedic Mattress - Midnight
