Quick answer

Put the harness on before your underwear, adjust the stretch straps so the pendant sits centered on your chest, and choose a tee that skims rather than clings. The Locker Room Harness has no buckles, so fit comes from strap tension and size, not hardware.

Why the no-buckle design changes how you adjust fit

Most harnesses rely on buckles or sliders to fine-tune fit. The Locker Room Harness uses stretch straps and a pull-on design, so the size you choose does most of the work. That means the fit check happens when you put it on, not after fiddling with hardware. If the straps feel loose, sizing down is usually more effective than trying to tighten anything.

Layering under a tee: what to expect

The harness has a 4cm zinc alloy pendant on a d-ring, which adds visible bulk under thin or tight shirts. A relaxed-fit tee or a heavier fabric hides the pendant better than a slim-fit jersey. If you want the harness to show, wear it over a fitted tee or on bare skin; if you want it hidden, treat the pendant as the deciding factor and pick a shirt with room across the chest.

When the harness is the statement, not the layer

The bold striped straps and gold-tone pendant are designed to be seen. Wearing the harness over a plain tee or on bare skin gives it room to stand out. In that case, skip the hidden-layer logic and focus on strap placement: the pendant should sit flat against your sternum, not twist to one side.

Step-by-step: putting on and layering your Locker Room Harness

  1. Start with the harness, not your underwear: Step into the harness or pull it over your head before putting on briefs, jock, or thong. The stretch straps can twist if you try to add the harness after dressing. Check that the front pendant hangs centered and the straps lie flat against your skin. If the straps twist, take the harness off and reset it rather than tugging them straight.
  2. Set the pendant position: The 4cm pendant should rest on your sternum, roughly mid-chest. If it sits too high near your collarbone or too low near your stomach, the harness is either too small or too large. Adjust by choosing a different size, not by pulling the straps. A centered pendant is the quickest sign the size is right.
  3. Check strap tension without overstretching: The stretch straps should lie flat with no digging or sagging. You should be able to slide a finger under each strap, but not a whole hand. If the straps leave red marks after a few minutes, size up; if they slide off your shoulders, size down. Do a two-minute wear test before layering anything over the harness.
  4. Choose your layer based on the pendant: For a hidden look, pick a relaxed-fit tee or a heavier fabric that skims over the 4cm pendant. For a visible look, wear the harness over a fitted tee or on bare skin. Avoid thin, tight shirts if you want the harness concealed, because the pendant will show through. The pendant, not the straps, decides whether a shirt works as a cover layer.
  5. Match the rest of the outfit to the Chalk colorway: Chalk is a light neutral, so it pairs cleanly with black, grey, navy, or white bottoms. The gold-tone pendant adds warmth, so keep other hardware minimal if you want the harness to stay the focal point. If you wear the matching Locker Room Jock, Thong, or socks, let the harness be the only statement piece. Light colorways show sweat and deodorant marks more than dark ones, so check before a long wear.

Product facts

  • Locker Room Harness - Chalk: Stretch straps with no buckles to fiddle with. Fit depends on choosing the right size rather than adjusting hardware, so check the size chart before ordering.

    Locker Room Harness - Chalk

    Locker Room Harness - Chalk

  • Locker Room Harness - Chalk: Gold, refined, dog tag inspired zinc alloy 4cm pendant attached to a d-ring. The pendant is the bulkiest point, so it determines whether the harness disappears under a tee or shows through.