What This Replacement Part Does

The Fan Housing Ring + Blade Screw for the Whisper Flex 2 (Smart) in White is a direct replacement part designed to secure the blade assembly to the housing. If your fan's original ring or screw is damaged, lost, or worn, this kit provides the mounting screws needed to restore proper operation.

Before you begin, verify that your fan model is listed as compatible: DXCF71, DXCF81, or DXCF89. These models cover both the standard Whisper Flex 2 and the Smart versions. The part comes in White, so it matches the original finish on white fan units.

Installation Steps

Follow these steps to replace the fan housing ring and blade screw on your Whisper Flex 2 fan. Work in a clean, well-lit area and keep the small screws organized.

  1. 1. Unplug and prepare the fan: Disconnect the fan from power. Place it on a stable, flat surface. Remove any front grille or blade assembly that may be attached, following your fan's manual for disassembly.
  2. 2. Remove the old ring and screw: Locate the existing fan housing ring and blade screw. Unscrew and remove them carefully. Set aside any washers or spacers if present.
  3. 3. Align the new ring and screw: Take the new Fan Housing Ring + Blade Screw from the kit. Align the ring with the mounting holes on the fan housing. Insert the screw through the ring and into the threaded boss.
  4. 4. Tighten securely: Hand-tighten the screw until it is snug. Do not overtighten, as this could strip the threads or damage the plastic. A firm, even pressure is sufficient.
  5. 5. Reassemble the fan: Reattach the blade assembly and front grille according to your fan's instructions. Plug the fan back in and test operation at a low speed to confirm everything is secure.

Product Details

What the Supplied Information Does Not Cover

The available product details do not include a full set of step-by-step instructions for this specific replacement. The steps above are based on general fan disassembly practices and the part's intended function. Always refer to your fan's original manual for model-specific disassembly and reassembly procedures.

If your fan model is not listed as compatible (DXCF71, DXCF81, DXCF89), do not use this part. Contact Duux support for the correct replacement part for your unit.