Quick Answer

To install the Top Light Brace and Light on your HM124, first remove the old or damaged parts, then align the new brace with the chassis mounting holes, secure it with the screws, and finally connect the light wires to the receiver or lighting module.

Why Use the Genuine BEZGAR Part?

The Top Light Brace and Light (part number 90142) is a genuine BEZGAR spare part designed specifically for the HM124 model. This ensures a proper fit without modification and reliable performance. Using a non-original part may require drilling extra holes or cause the light to sit crookedly.

Installation Steps

  1. 1. Prepare the Car: Place your HM124 on a clean, flat surface. Remove the body shell by releasing the body clips or screws. Disconnect the battery to avoid accidental power while working. Common mistake: Forgetting to disconnect the battery can cause the light to turn on unexpectedly during installation, which is annoying and could short the wires.
  2. 2. Remove the Old Parts: If replacing a damaged top light assembly, unscrew the two small screws holding the old brace to the chassis. Gently pull the light wires from the receiver or lighting module. Set the old parts aside. Checkpoint: Note how the old wires are routed so you can replicate the path with the new part.
  3. 3. Attach the New Brace: Take the new Top Light Brace (90142) and align its two mounting holes with the corresponding posts on the chassis. Insert and tighten the screws firmly but do not overtighten, as the plastic can strip. Common mistake: Overtightening can crack the brace or the chassis mounting posts. Stop when the brace is snug and does not wiggle.
  4. 4. Connect the Light Wires: Plug the light connector into the same port on the receiver or lighting module as before. If you are adding lights for the first time, connect to a free channel (often channel 2 or an auxiliary port). Ensure the polarity matches. Checkpoint: If the light does not turn on when testing, reverse the connector polarity or try a different channel.
  5. 5. Test and Secure Wires: Reconnect the battery and turn on the transmitter, then the car. Verify the top light works. If it does, turn everything off again. Use a small zip tie or tape to secure the wires away from moving parts like the steering linkage. Common mistake: Loose wires can get caught in the drivetrain or steering, causing damage. Always tuck them neatly.
  6. 6. Reinstall the Body Shell: Once the brace is secure and wires are routed, place the body shell back over the chassis. Align the shell's mounting holes and press the body clips or screws back in place. Your HM124 is ready to drive with its new top light. Checkpoint: Ensure the body shell does not pinch the light wires. If it does, reroute the wires slightly.

Product Details

  • Top Light Brace and Top Light(90142) for HM124: Original BEZGAR spare part, 100% applicable to HM124 models, part number 90142 includes both the top light brace and the top light assembly. You get a drop-in replacement that matches the factory mounting points and wiring, so installation is straightforward without needing to modify the chassis.

    Top Light Brace and Top Light(90142) for HM124

    Top Light Brace and Top Light(90142) for HM124