Quick answer

Display your Madoka Kaname Rabbit Ears 1/4 scale figure on a stable, low-traffic shelf away from direct sun, and dust it every two to four weeks with a soft brush and gentle air puffs. Always support the figure at the base and avoid gripping the rabbit ears or dress details during cleaning.

Why a 1/4 scale figure needs a different display approach

At 1/4 scale, this Madoka figure is larger and heavier than most standard figures, so stability and clearance matter more than with smaller pieces. A shelf that feels fine for a 1/7 scale figure may flex or crowd a 1/4 scale display, especially when the pose extends outward.

The rabbit ears and one-piece dress add fragile, protruding details that can catch on sleeves, shelf edges, or cleaning tools. Plan your display so those parts have open space around them rather than sitting tight against a wall or another figure.

When to skip the display case and when it is worth it

An enclosed display case reduces dust and accidental contact, but it is not mandatory. If your room has heavy foot traffic, pets, or frequent cooking smoke, a case or a cabinet with doors will save you cleaning time and lower the risk of knocking the figure.

If you prefer open display, place the figure higher than waist level and back from the shelf edge. The tradeoff is more frequent dusting, so keep a soft brush within reach and accept that the ears will need attention every few weeks.

Step-by-step display and care routine

  1. Choose a stable, sun-free shelf: Pick a shelf that does not wobble and is out of direct sunlight. Check that the shelf can hold the figure's weight without bowing, and leave at least a few centimeters of clearance behind and above the rabbit ears. Common mistake: placing the figure near a window where UV and heat can dull colors over time. Push the shelf gently before placing the figure; if it flexes or rocks, choose another spot.
  2. Set the figure down from the base: Hold the figure by its base or the most solid part of the lower body, never by the rabbit ears or outstretched dress edges. Lower it straight down onto the shelf and check that it sits flat without rocking. Common mistake: lifting or repositioning the figure by an ear, which can bend or stress the sculpt. After placement, look at the figure from the side to confirm the base is fully supported.
  3. Dust with a soft brush and gentle air: Every two to four weeks, use a clean soft brush to sweep dust from the top of the head downward, then use a camera air blower to push dust out of the dress folds and around the rabbit ears. Work over a soft surface in case a small part loosens. Common mistake: using a cloth directly on the figure, which can drag dust and scratch glossy paint. If you see dust building on the ears between cleanings, increase frequency rather than brushing harder.
  4. Clean the rabbit ears without pulling: Support the head with one hand while brushing the ears with the other, moving the brush in the direction the ear points. Never pull or twist the ears to reach a spot. Common mistake: gripping an ear to steady the figure while dusting the face. Stop if an ear feels loose or moves more than expected, and check the attachment point before continuing.
  5. Handle the dress details with care: Use the air blower first on dress folds and ruffles, then a brush only if needed. Avoid pressing on thin edges or using water near painted seams. Common mistake: spraying cleaning fluid directly on the figure; if you must use a slightly damp cloth, apply it to the cloth first and keep it away from the ears and face. Keep liquids off the figure entirely unless the manufacturer's instructions say otherwise.
  6. Recheck stability after any move: Whenever you move the figure for cleaning or rearranging, place it back on a flat surface and confirm it does not rock. If the shelf is in a high-traffic area, consider museum putty or a display case with a door. Common mistake: assuming the figure is stable because it stood fine before the move. A figure that rocks after repositioning should be moved to a flatter surface before you leave it.

Product facts