What the Mega-Magg kit includes
The Mega-Magg is an advanced-level kit from the LOC-CUSTOM SERIES, designed for high-power motor capabilities. It features a factory pre-slotted airframe and through-the-wall fin construction. The kit comes with a 5.5" MMAS motor mount system and a 54mm adaptor, plus the RNWS removable nose weight system. A 60" ripstop nylon parachute is included (color random). The shock cord is a 5/8" tubular Y harness with 1x18' tubular nylon with sewn loops.
Motor mount setup with the MMAS system
The MMAS (Multi-Mount Adapter System) lets you choose your motor configuration. The kit includes a 54mm adaptor, so you can fly with either a 5.5" motor or a 54mm motor. Before gluing, test-fit the adaptor and the motor you plan to use. The supplied instructions cover only the MMAS and RNWS systems, so you may need to refer to general high-power build guides for the rest of the assembly.
Fin installation sequence
The through-the-wall fin tabs slide into the pre-slotted airframe. This design provides a strong bond and better alignment than surface-mounted fins.
- Dry fit the fins: Insert each fin into its slot without glue. Check that the tabs seat fully and the fins are perpendicular to the airframe. Sand the tabs lightly if they bind.
- Mark alignment lines: Use a long straightedge to extend the fin centerlines onto the airframe. This helps you keep fins straight during gluing.
- Apply epoxy to the fin tabs: Use a high-strength epoxy suitable for high-power rockets. Apply a thin layer to the tab and inside the slot. Insert the fin and remove excess epoxy.
- Add external fillets: After the internal bond cures, apply epoxy fillets along the fin-to-airframe joint. The fin thickness is 3/8", so plan fillets that cover the joint fully.
Recovery system preparation
The 60" ripstop nylon parachute is large enough for the 7 lb rocket, but you need to pack it carefully to avoid tangling. Use a nomex or flame-resistant blanket to protect the chute from ejection gasses. The shock cord setup includes a Y harness and 18' of tubular nylon—this length gives good separation between the nose cone and airframe during deployment.
Key specifications
-
Mega-Magg: Height: 52", Weight: 7 lbs, Diameter: 7.6" These dimensions tell you the rocket requires a large flying field and a robust launch pad. The recommended pad is the RB-1500 for 15 series rails.
Mega-Magg
-
Mega-Magg: Motor Mount: 5.5" MMAS with 54mm adaptor included You can fly with either a 5.5" or 54mm motor. The MMAS system gives flexibility, but you need to source motors separately and ensure they fit the adaptor.
-
Mega-Magg: Complexity: Advanced This kit is not for beginners. Expect to need experience with epoxy, fin alignment, and high-power recovery setup.
Flight preparation tips
Before the first flight, do a ground test of the ejection charge with the RNWS nose weight system installed. Verify that the nose cone separates cleanly and the parachute deploys. The RNWS system lets you adjust nose weight for stability—check the center of gravity (CG) with the motor installed. On the launch pad, use a 15-series rail (RB-1500 recommended). The rocket is heavy, so ensure the rail is securely anchored.
