Quick answer
Choose your usual men's top size for the Competitor Lite Printed Singlet and expect an athletic, close-to-body fit with a racerback cut. If you are between sizes or want more room across the chest, size up; if you want a race-tight feel, stay true to size.
What the athletic fit means in practice
The Competitor Lite is cut as a running tank, not a loose gym tee. The fabric should sit close to your torso without pulling at the armholes or riding up when you swing your arms. A racerback cut gives your shoulders room to move, but the body of the singlet stays fairly trim.
That trim cut is the point: less loose fabric means less chafing and less drag on warm race days. The trade-off is that it leaves little margin for error in sizing, so measure before you order rather than assuming your casual tee size will feel the same.
When to size up or stay true to size
Size up if you have a broader chest or shoulders, prefer a relaxed training fit, or plan to wear the singlet over a sports bra or base layer. Stay true to size if you want the intended race fit and will wear it alone.
If you are genuinely between two sizes, pick the larger one for training and the smaller one only if you have worn a similar racerback tank before and know you like a tight fit. There is no stretch panel to compensate for a size that is too small.
Caring for the lightweight fabric
The moisture-wicking fabric is designed to move sweat away from your skin, and that performance degrades if you wash it with fabric softener or dry it on high heat. Turn the singlet inside out, wash it cold with similar synthetics, and hang it to dry.
The printed Uglier Sweater design is a surface print, so avoid ironing directly on the graphic and skip the dryer sheet. A gentle wash cycle and air drying keep both the print and the wicking finish intact for more race days.
How to dial in your Competitor Lite fit and care
- Measure your chest and compare to the size chart: Wrap a tape measure around the fullest part of your chest, keep it level, and match the number to the size chart rather than guessing from your T-shirt size. If your measurement lands between two sizes, size up for training and stay true to size only for race day.
- Check shoulder and armhole clearance: Try the singlet on and raise your arms overhead. The racerback should let your shoulders move without the armholes digging in or the hem lifting past your waistband. If the armholes pull or the hem rides up, go up a size.
- Test the body fit with your race-day layers: Wear the singlet with whatever you plan to race in underneath, such as a sports bra or base layer, and check that the fabric lies flat without bunching. Layers change the fit, so test with them before you commit.
- Wash cold and air dry after every run: Turn the singlet inside out, wash it on a cold gentle cycle with like fabrics, skip fabric softener, and hang it to dry away from direct heat. Never put the printed singlet in a hot dryer; heat can set odor and damage the print.
Product facts
-
Men's Competitor Lite Printed Singlet - Uglier Sweater: Lightweight, moisture-wicking fabric with a racerback cut and athletic fit. The fabric dries quickly and the racerback improves arm range, so the singlet suits warm races and high-energy training.
Men's Competitor Lite Printed Singlet - Uglier Sweater
