What This Cable Does

A Mini SAS HD SFF-8644 to 4 SATA breakout cable lets you connect a Mini SAS HD controller directly to four SATA hard drives or SSDs. It's a forward breakout design, meaning the single SFF-8644 end plugs into the host (like a RAID controller or SAS host bus adapter), and the four SATA connectors link to individual drives. This is a common way to expand storage in servers, workstations, and enterprise storage systems without needing a separate backplane or expensive SAS drives.

Key Specifications at a Glance

  • Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m: Mini SAS HD SFF-8644 host connector on one end, four SATA 7-pin connectors on the other. This confirms the cable is designed for controllers with SFF-8644 ports, not older SFF-8087 or SFF-8643 ports.

    Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m

    Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m

  • Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m: Compatible with RAID controllers and SAS host bus adapters. If your controller uses a different interface (e.g., SFF-8643 or SlimSAS), this cable won't fit. Always verify your host port type.

  • Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m: Cable length: 1 metre. At 1 m, it's suitable for short runs inside a chassis or between adjacent rack units. For longer distances, you may need an extension or a different cable.

  • Mini SAS HD SFF-8644 to 4 SATA Breakout Cable 1m: Forward breakout design for connecting SATA drives to SAS controllers. This is the correct direction for adding SATA drives to a SAS host. A reverse breakout cable would do the opposite and is not what you need here.

Compatibility Check Before You Buy

Before purchasing an SFF-8644 to 4 SATA breakout cable, confirm three things: the host port type, the number of drives you need to connect, and the physical space available. This cable uses a Mini SAS HD SFF-8644 connector on the host side — common on newer RAID cards and SAS HBAs but different from the older SFF-8087 or the smaller SFF-8643. If your controller has an SFF-8643 port, you'd need a different cable. The four SATA ends are standard 7-pin connectors that work with any SATA drive. Also, the 1 m length is fixed; if your drives are farther away, consider cable management or a longer solution.

Where This Cable Fits Best

This cable is ideal for adding four SATA SSDs or HDDs to a server or workstation that already has a compatible SAS controller. It's commonly used in RAID arrays, storage servers, and enterprise storage systems where you want to use lower-cost SATA drives without replacing the controller. Because it's a forward breakout, it handles the signal direction correctly — from the SAS host to SATA targets. Just keep in mind that the supplied information doesn't specify maximum data transfer rates or power delivery details, so check your controller's specs for supported speeds and ensure your drives have their own power connection.