What the Kit Contains and Why It Matters
When you open a Lucent Lightshop mounting hardware kit, you get a set of components designed to attach a flush-mount fixture securely to a ceiling electrical box. Each piece serves a specific purpose, and knowing what it does helps you install the fixture correctly and avoid returns or safety issues.
The kit includes a threaded crossbar with ground screw, a plastic safety cap, a tightening nut, a threaded stem, a finish cap, two 6/32 machine screws, and three wire nuts. The stem comes in two lengths—2" and 4"—depending on the fixture you are mounting.
Mounting Hardware Kit Contents at a Glance
-
Mounting Hardware: Contains: (1) threaded crossbar with ground screw (1) plastic safety cap (1) tightening nut (1) threaded stem (1) finish cap (2) 6/32 machine screws (3) wire nuts This list tells you exactly what is in the package so you can verify you have everything before starting the installation.
Mounting Hardware
-
Mounting Hardware: Replacement mounting hardware for the following flush mounts: Triune fixtures require: 2" stem; 12 Orb flush mount requires: 4" stem; All sputnik flush mounts require: 4" stem Not all flush mounts use the same stem length. Matching the stem to your specific fixture is essential for proper fit and safety.
Why the Stem Length Matters
The threaded stem is the piece that connects the fixture to the ceiling plate. If the stem is too short, the fixture will not reach the crossbar. If it is too long, the fixture may hang lower than intended or leave an unsightly gap.
According to the supplied compatibility information, Triune fixtures need a 2" stem, while the 12 Orb flush mount and all sputnik flush mounts require a 4" stem. The kit is available in both lengths, so you can choose the right one for your fixture.
What Each Component Does
The threaded crossbar with ground screw attaches to the ceiling electrical box and provides a secure mounting point. The ground screw is where you connect the fixture's ground wire for safety.
The plastic safety cap fits over the wire connections inside the canopy. Its job is to protect the wire nuts and prevent accidental contact with live wires.
The tightening nut secures the stem to the crossbar. The finish cap then covers the nut and the crossbar for a clean, finished look.
The two 6/32 machine screws are used to attach the fixture's mounting strap or canopy to the crossbar. The three wire nuts are for connecting the fixture wires to the house wiring.
Choosing the Right Kit for Your Fixture
If you are replacing lost or damaged hardware, check the stem length required by your fixture. The product records show that Triune fixtures need a 2" stem, while the 12 Orb and sputnik flush mounts need a 4" stem. The kit is available in both lengths and in two finishes: Modern Brass and Black.
If your fixture is not one of those listed, the catalog does not specify a stem length. In that case, measure the distance from the ceiling plate to the fixture canopy to determine which stem you need.
