Quick answer

Set up your Tier 1 Concealed OWB Magazine Carrier by adjusting retention, angle, and belt fit. Follow these steps for a secure, comfortable carry.

Why proper setup matters

An OWB magazine carrier that is not adjusted correctly can print under clothing, shift during movement, or fail to retain the magazine when you need it most. Taking a few minutes to dial in retention and cant ensures the carrier works with your holster and body mechanics, not against them.

The Tier 1 Concealed OWB Magazine Carrier is designed to fit most belts up to 2 inches wide and includes the X-Lock system for secure attachment. However, the exact feel depends on your belt thickness and personal carry position.

Setup steps

  1. 1. Attach the carrier to your belt: Slide the X-Lock belt clips onto your belt at your preferred carry position (typically 8:00 to 9:00 for right-handed, 3:00 to 4:00 for left-handed). Ensure the clips are fully seated and the carrier sits flat against your body. Common mistake: clipping over a belt loop or too far forward, which causes the carrier to tilt. Check that the carrier is centered on your belt, not on a loop.
  2. 2. Adjust magazine retention: Tighten or loosen the retention screws on the carrier body until the magazine clicks in firmly but can still be drawn with a smooth, deliberate pull. Overtightening can make the magazine hard to remove; under-tightening risks it falling out. Test retention by shaking the carrier upside down. If the magazine stays, retention is sufficient for daily carry.
  3. 3. Set the magazine angle (cant): Loosen the angle adjustment screws and tilt the carrier to your preferred cant (usually 0 to 15 degrees forward). Tighten the screws securely. A forward cant helps the magazine sit closer to your body and can improve concealment. If the carrier feels like it's poking into your side, try a steeper forward cant. If the magazine grip hits your elbow, reduce the cant.
  4. 4. Verify belt fit and stability: With the carrier on, walk, bend, and sit to check for shifting. The X-Lock should hold the carrier in place. If the carrier slides, your belt may be too narrow (under 1.5 inches) or too thick (over 2 inches). A loose belt clip is the most common cause of carrier movement. If the clip doesn't lock, try a different belt or adjust the clip tension.
  5. 5. Practice drawing and reholstering: With an unloaded magazine, practice drawing and reinserting the magazine several times. Smooth out any snags or resistance. Adjust retention or angle as needed until the motion feels natural. Dry practice at home reveals issues you won't notice while standing still. Recheck retention after a few draws, as screws can loosen over time.

Product facts

  • OWB - MAGAZINE CARRIER: LIFETIME WARRANTY, fits most belts up to 2 inches, X-Lock system included, adjustable retention and angle. The lifetime warranty gives long-term confidence, while the X-Lock and adjustable features let you fine-tune the carrier to your belt and preferred draw angle.

    OWB - MAGAZINE CARRIER

    OWB - MAGAZINE CARRIER