What You Get in the Set

The Penal Guard Arms with Laser Rifles (Male) set contains 5 different pairs of laser rifle arms. Each pair is designed for a male penal guard figure and includes the arms and the laser rifle as a single piece. The arms are hand cast in high quality resin and are compatible with Victoria Miniatures and popular plastic guard bodies.

Preparation for Assembly

Resin miniatures require a bit of preparation before assembly. Wash the arms in warm, soapy water to remove any mold release residue. Let them dry completely. Use a hobby knife or fine sandpaper to remove any mold lines or flash. Dry-fit each arm pair to the body before gluing to ensure a good fit.

Because the arms and rifles are cast as one piece, there is no separate rifle to attach. This simplifies assembly but means you cannot swap rifles between arms. Choose the pose you want before gluing.

Assembly Steps

Follow these steps to attach the arms to your penal guard body.

  1. 1. Dry-fit the arms: Hold each arm pair against the torso to check alignment. The shoulder joints should meet the body's arm sockets without gaps. If needed, sand the joint flat.
  2. 2. Apply super glue: Use a thin layer of cyanoacrylate (super glue) on the shoulder joint. Press the arm into place and hold for the time recommended in the product instructions. Avoid using plastic cement, as it won't bond resin.
  3. 3. Fill gaps if needed: If there is a small gap between the arm and body, apply a tiny amount of gap-filling super glue or green stuff putty. Let it cure before painting.

Painting the Laser Rifles

The laser rifles are detailed and benefit from careful painting. Start with a black or dark grey primer. Paint the rifle body with a metallic or colored base coat, then drybrush with a lighter shade to bring out the edges. The rifle's barrel and scope (if present) can be picked out in a contrasting color. A wash of black or brown adds depth to the recesses.

For a classic sci-fi look, paint the rifle casing in a dark grey and the barrel in silver. Alternatively, match the rifle color to your penal guard's uniform scheme.

Painting the Arms and Hands

The arms are bare or have rolled sleeves, depending on the pose. Paint the skin with a flesh tone, then apply a wash and highlight. For rolled sleeves, paint the fabric in your guard's uniform color. The hands gripping the rifle should be painted carefully to avoid smudging the rifle itself.

Because the arms are resin, they hold paint well once primed. Use thin coats to preserve detail.

Key Facts About the Set

  • Penal Guard Arms with Laser Rifles (Male): 5 different pairs of laser rifle arms for male penal guard, with laser rifles. You get five unique poses, giving variety to your squad. Each pair is a single piece, so there is no separate rifle to attach.

    Penal Guard Arms with Laser Rifles (Male)

    Penal Guard Arms with Laser Rifles (Male)

  • Penal Guard Arms with Laser Rifles (Male): Compatible with Victoria Miniatures and popular plastic guard. These arms fit a wide range of bodies, including popular plastic guard kits, making them versatile for conversions.

  • Penal Guard Arms with Laser Rifles (Male): Hand cast in high quality resin. Resin requires preparation but holds fine detail well. Handle with care during assembly.