Check the SKU before you order the ballast
The PopSpot J-500 OEM Replacement Parts ballast is intended for units with SKUs starting with LED-J500. That prefix is the compatibility checkpoint the supplied information gives you, so verify it on your fixture or its packaging before you buy.
If your light does not carry an LED-J500 SKU, the supplied information does not confirm this ballast as the correct part. In that case, treat the purchase as unconfirmed rather than assuming the ballast will fit.
What the OEM ballast record confirms
-
Popspot J-500 OEM Replacement Parts - Replacement Ballasts for Fotodiox Pro PopSpot J-500 Focusing LED Light (for SKUs starting with LED-J500): Replacement ballast for the Fotodiox Pro PopSpot J-500 Focusing LED Light This is the part type the listing covers, so you can match it to the fixture you are repairing.
Popspot J-500 OEM Replacement Parts - Replacement Ballasts for Fotodiox Pro PopSpot J-500 Focusing LED Light (for SKUs starting with LED-J500)
-
Popspot J-500 OEM Replacement Parts - Replacement Ballasts for Fotodiox Pro PopSpot J-500 Focusing LED Light (for SKUs starting with LED-J500): Compatible with SKUs starting with LED-J500 The SKU prefix is the only compatibility rule shown in the supplied record, so it should drive your fit decision.
-
Popspot J-500 OEM Replacement Parts - Replacement Ballasts for Fotodiox Pro PopSpot J-500 Focusing LED Light (for SKUs starting with LED-J500): Part option: ballast; brand: Fotodiox, Inc. USA The listing is a single part option, which helps you avoid ordering a different PopSpot replacement component by mistake.
A supported order-and-swap sequence
The supplied record does not include installation instructions, so the steps below stop at the decisions the evidence can support. For the physical swap itself, use the documentation that came with your fixture.
- 1. Find your fixture SKU: Locate the label or listing that shows your PopSpot J-500 SKU and confirm it starts with LED-J500.
- 2. Order the ballast part option: Select the ballast option in the PopSpot J-500 OEM Replacement Parts listing; the supplied record shows ballast as the part option.
- 3. Keep the fixture identification with the part: Record the LED-J500 SKU alongside the replacement so you can confirm the match again if you service the light later.
- 4. Follow your fixture's own service guidance for the swap: The supplied information does not describe opening the light or removing the old ballast, so do not treat this article as an installation procedure.
What the supplied information leaves open
The record confirms the part type, the LED-J500 SKU compatibility, and the Fotodiox brand, but it does not include care, safety, or operating instructions. It also does not state power requirements, supported standards, or a step-by-step replacement method.
That absence is a limit of the supplied evidence, not a statement that the part cannot be installed. If you need those details before starting, check the documentation that came with your PopSpot J-500 or contact the seller rather than guessing.
When this ballast is the right purchase
Choose this OEM replacement when your Fotodiox Pro PopSpot J-500 Focusing LED Light carries an LED-J500 SKU and you have identified the ballast as the part you need. The listing keeps the part option narrow, which makes the SKU check the main decision.
If your SKU falls outside the LED-J500 range, the supplied information does not support this as a confirmed replacement. Look for a part whose compatibility record matches your fixture instead of relying on the PopSpot name alone.
